Question about windshield gaskets

[spankybear]

I went out and spent big bucks on a new windshield gasket. When UPS finally got it here I see it's not the same as the one that was on the windshield. There is no corner molded in to the gasket like the picture below. It looks like the profile is the same just no molded corner. So my question is will the one with the corner seal better than the one without? I have been looking at pictures of LMTV windshields and it seem over half the ones I looked at have the molded corner. Any thoughts on this?

 

[jkcondrey]

Not sure Ill be much help, but my gaskets do not have that profile in the corner either. I have an LVAD, so it may be different style.

 

[Berend]

I went out and spent big bucks on a new windshield gasket. When UPS finally got it here I see it's not the same as the one that was on the windshield. There is no corner molded in to the gasket like the picture below. It looks like the profile is the same just no molded corner. So my question is will the one with the corner seal better than the one without? I have been looking at pictures of LMTV windshields and it seem over half the ones I looked at have the molded corner. Any thoughts on this?

View attachment 798048

If you don’t mind me asking , how much was the gasket and where did you get it ?


Verzonden vanaf mijn iPhone met Tapatalk

 

[spankybear]

Tax and shipping was 355 bucks (USD). I got it from SECO... I will not buy from them again. Their website said it was 312 plus shipping but they charged me 318..00 plus tax and shipping. They have an ebay listing for 322.00 plus like 19.00 shipping and tax.

I should have just used the old one. There are a couple of tears in the old gasket that I fixed. I just don't want any leaks as i did some rust repair along the window opening.

I guess you can get them over in Europe From Styer but I could not find anyplace to get them.

 

[Suprman]

I have the steyr part number. Just as expensive though. I have been hunting for a generic. Has to be something out there. I can get the windshields from the manufacturer cheap.

 

[Berend]

I can get the windshield gaskets for $185 plus shipping. My guess shipping to the usa is around $30-$40


Verzonden vanaf mijn iPhone met Tapatalk

 

[spankybear]

Well Dang... I also bet shipping would be faster than UPSssssllloowww. Are they the style with molded corners?

I was looking at "universal" types and found some that may work... but didn't want to take the time to do the try out...

More Information for METRO LP30G

www.rockauto.com

More Information for METRO LP30U

www.rockauto.com

Metro Moulded Parts ~ Top Quality Automotive Weatherstripping and Rubber Parts

 

[Ronmar]

The only benefit I can see with the molded corners is it allows the outer/surface lip seal to lay out a little flatter against the skin on the lower corners. Probably not a big deal... as there are several lip seals that contact the body down in the window recess/opening...

 

[Reworked LMTV]

keep your windshield gasket treated with ATP 205 for future changes.

 

[RandomThinker]

Hey Berend, is that for the LVAD M1081? Do you happen to have a link/source or a part number on where to get them?