- 753
- 1,332
- 93
- Location
- Highland, Indiana
After installing the rear hatch with new seal, it feels like it's catching on top of seal when I open. Is it just because it's a new seal or because I installed it wrong?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Slantback hatch gasket question.
- Thread starter Mattguy
- Start date
- 753
- 1,332
- 93
- Location
- Highland, Indiana
Lubricate the seal?
- 753
- 1,332
- 93
- Location
- Highland, Indiana
Here is the seal after install. I can get pictures tomorrow of where in it binds.
I don't know this application specifically but a little lube can help the parts slide past each other. You MUST NOT use petroleum based lubricants for the EPDM rubber seals. Use silicone or Teflon based lubricants only. Your DOT 5 brake fluid actually works well here as it is silicone oil.
- 753
- 1,332
- 93
- Location
- Highland, Indiana
I have some spray silicone I can use. Used on vent seals for my D30. I'll try it out!
- 753
- 1,332
- 93
- Location
- Highland, Indiana
The top of the gasket is supposed to be under the top bar. That's how it seals.. just figured it out!
M1028A1ShelterCarrier
Active member
- 230
- 76
- 28
- Location
- Mammoth Lakes Ca.
Do you have any pictures? Same problem here. Im not so sure its designed to be underneath and without the armor overlay pinching/keeping it in position. Did you use adhesive? Just ordered another seal after spreading the first one too open at the top. Thanks
- 155
- 226
- 43
- Location
- North California, USA
I should receive a new seal this week therefore I’m also curious 
Did you end up taking the armor overlay off for this job?
M1028A1ShelterCarrier
Active member
- 230
- 76
- 28
- Location
- Mammoth Lakes Ca.
Yes, appears to be working with the upper portion installed under the lip. For how long, who knows...