290smallcam
Active member
- 150
- 36
- 28
- Location
- peru,indiana
Would this be a ok set up? The 6453 are super cheap out there. Would it need any special parts? Would it bolt right up on a 12 valve with a SAE#2 housing. Has anyone done it?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Spicer 6453 to 12 valve?
- Thread starter 290smallcam
- Start date
290smallcam
Active member
- 150
- 36
- 28
- Location
- peru,indiana
No thoughts 
davidb56
Well-known member
- 1,020
- 1,237
- 113
- Location
- Bonners Ferry Idaho
there must be a reason that nobody seems to have done it. Have you checked the input shaft on both transmissions? maybe one is shorter or the pilot is different. That would be a good place for You to start.
deathrowdave
Active member
- 387
- 81
- 28
- Location
- falmouth, ky
Should bolt right up , just don’t know if it’s rated for the BT , torque output . SAE 2 for the BT maybe a bit tuff . I had a few SAE 3 but never a SAE 2
davidb56
Well-known member
- 1,020
- 1,237
- 113
- Location
- Bonners Ferry Idaho
Sorry, I got my transmissions mixed up with another thread. Now I don't have a clue what Im even commenting on.. Iv'e went from sharp as a pin at 55 years old, "to where in the hell am I , and how did I get here", at 65 years old.