WarHorse_Alex
Active member
- 66
- 237
- 33
- Location
- Russia
Are you know - that rust looks real nature camo xDDDD Green on greenish, ginger on yellow xDDD
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
The Green Croc.... My monster KrAZ-255B1
- Thread starter WarHorse_Alex
- Start date
WarHorse_Alex
Active member
- 66
- 237
- 33
- Location
- Russia
Just was try to put it in maximum angles and check, how frame can be bent... Muzzle is split from cab and hood. Radiator core, front grille, engine mount on front part of frame tight, cab and hood are more beyond, and in case of diagonal angles frame slightly bent - this is absolutely normal - elasticity of frame and can be see at pics....
Attachments
WarHorse_Alex
Active member
- 66
- 237
- 33
- Location
- Russia
How Green Croc help in farm deals xDDD First and main action - is 'mud cruiser' xDDDD Last mile around farm and fields, where is no roads are heavy for pass at rains and spring season. There is LR fans also!!!! So, we can think, that military vehicle collection is expand xDDDD
Attachments
WarHorse_Alex
Active member
- 66
- 237
- 33
- Location
- Russia
Last edited:
dmetalmiki
Well-known member
- 5,523
- 2,028
- 113
- Location
- London England
here are the pictures of the levers. WHAT do they all do in which position???
Attachments
dmetalmiki
Well-known member
- 5,523
- 2,028
- 113
- Location
- London England
Thank you so much. I only see this just now.
not anywhere in posts..site VERY difficult to navigate.
Again thank you.
tomorrow we take Kraz out for a drive.
dmetalmiki
Well-known member
- 5,523
- 2,028
- 113
- Location
- London England
I now see that the other owner before me has wires every wrong!.
the start switch not wired
the pre heat
not wired.
Lucky my Kraz starts at one touch of button every time. (I put a switch in).
I am to wire up the start and heat switch properly.
- 6,426
- 4,985
- 113
- Location
- Ft. Lauderdale, Florida
You must expand on what the heck all those shifter do
Pull the floor boards and research and take photos.
Pull the floor boards and research and take photos.
- 16,766
- 24,074
- 113
- Location
- Burgkunstadt, Germany
I am trying to get someone who CLAIMS, to know something about the KRAZ to tell me a few things, and maybe provide the TM's, in German. He told me he drove the KRAZ in the DDR army, and has some experience. We shall see.
WarHorse_Alex
Active member
- 66
- 237
- 33
- Location
- Russia
He even can not to pull the floor. Most of levers have rods behind the cab. It can be inspect from under the truck...
WarHorse_Alex
Active member
- 66
- 237
- 33
- Location
- Russia
Hmmm... Navigate... I not think so. This site has one of best engines - I saw many others more and more terrible )))))))) - just look at upper right corner of site 'dashboard' - it have a bell with your personal notification about each likes and replies and also it have PM - conversation here - it same - 'post envelope' also inform you about each new message... Just every time, when you open this forum - check it first...
I can tell also, that take attention - on hard pavements not only front axle must be OFF - 'left far to rear wall of cab' lever - rear interaxle lock - must be in OFF position!!!!!
One of required procedure (for myself) every time, when I seat in driver chair - check all of that levers. Because in my truck winch lever and interaxle lock goes very easily and can be shift accidentally.
WarHorse_Alex
Active member
- 66
- 237
- 33
- Location
- Russia
How it was started before? What was as starter switch from preowner?
The levers are as follows, left to right, to the best of my memory, from top position to bottom:
Intermediate axle differential (on/off)
Transfer case (high forward/low rear)
PTO (off/on?)
Bed dump control (up/neutral/down)
...BUT...
Earlier trucks had the intermediate switch on top of the dash, next to the glovebox.
Transfer case switch in middle of dash.
PTO next to glovebox.
Bed dump control on the floor/near front seat mounts as I recall.
Intermediate axle differential (on/off)
Transfer case (high forward/low rear)
PTO (off/on?)
Bed dump control (up/neutral/down)
...BUT...
Earlier trucks had the intermediate switch on top of the dash, next to the glovebox.
Transfer case switch in middle of dash.
PTO next to glovebox.
Bed dump control on the floor/near front seat mounts as I recall.
WarHorse_Alex
Active member
- 66
- 237
- 33
- Location
- Russia
It's scheme for 6x4 dump truck - 257/258 models... Not for our case...
What is PTO? Hydraulic pump?
dmetalmiki
Well-known member
- 5,523
- 2,028
- 113
- Location
- London England
PTO winch? I think.
I have no winch, My other Kraz for spares has winch. It comes in one month.
I have no winch, My other Kraz for spares has winch. It comes in one month.
- 6,426
- 4,985
- 113
- Location
- Ft. Lauderdale, Florida
Golly Gee Whizz, You got the disease!
- 3,800
- 2,828
- 113
- Location
- Peoria, Illinois
I agree with the other's !! Wonderful machine! Wonderful story! New lease on life for the monster beast! I have dreams of Eastern Bloc equipment, but I don't have a deep enough wallet! LOL THANKS for sharing!!