What have you done to your HMMWV today/lately

[SmartDrug]

Installed grab handles for each of the four seat positionsView attachment 862600View attachment 862600

I need those! Did you make them or buy them?

 

[Mattguy]

Antenna install today. VSQ-1

 

[GuntherRommel]

Nice, I did the same thing yesterday

 

[85 USMC M998]

Shield, Fuel Tank
Guys looking for some help. Trying to figure out where this goes?
PN 12460102
Thanks in advance!

 

[Action]

On the outside of the fuel tank. The skinny rectangular part sits on top with isolatirs in line with the straps on sides.
On newer tanks, 12460105. Not sure about old tank.

 

[85 USMC M998]

On the outside of the fuel tank. The skinny rectangular part sits on top with isolatirs in line with the straps on sides.
On newer tanks, 12460105. Not sure about old tank.

I have an old tank. I’ve been trying to figure it out and gave up. Is it on the front or rear of the tank. Thanks

 

[85 USMC M998]

I did get the rear protection on.

 

[85 USMC M998]

Working on the middle then moving forward. Man I wish my crossmembers had holes pre-drilled.

 

[Action]

I have an old tank. I’ve been trying to figure it out and gave up. Is it on the front or rear of the tank. Thanks

Against driveshaft towards front. Just look in the parts TM e
.
.

 

[85 USMC M998]

Against driveshaft towards front. Just look in the parts TM View attachment 862650e
.
.

Many Thanks!
I must have a old TM as I could not find it.

 

[OBX]

I need those! Did you make them or buy them?

Bought them. These are fixed price, no auction, so I hope this doesn’t violate any rules here. Indestructible. Great value. You get 4ea for one price.

Find eBay sellers ”Sub4411” and ”Wartimefinds“ For these and other size MV grab handles.

 

[GuntherRommel]

Wired in led lights on the B piller, one for each seat

 

[HUNvee]

My wheel got punctured today. (Durawall puncture resistant-bullshit)
Unfortunately my wheels are 24 bolt MT/Rs my spare wheel is a 12 bolt MT.
Good luck, she made it home.
I have a spare rim, but I need to get a tire.

 

[Mattguy]

Today I used my vinyl cutter to make rear decals for truck. Not to bad, may need to get matte black vinyl.

 

[Gcelevator]

While waiting on the engine, i am making this seat base of some aluminum i had in my office. Better than paying for the original bases.

 

[GuntherRommel]

Awesome man, semi-armored set bases . will they latch in ? or just be bolted in

 

[Gcelevator]

Awesome man, semi-armored set bases . will they latch in ? or just be bolted in

Theyvwill be loted in. I will install riv-nuts in the original lifted section and countersink the aluminum to hide the head of the screw. Might make a access door in the front of the passenger rear base so i can use it as storage. At least this will give me a good support for the rear seats.

 

[GuntherRommel]

Agreed, the seat bases are gay

 

[Mattguy]

Finishing up my license bracket holder with light for airlift bumper. I wasn't about to pay $89 for a kit. Good excuse to break out the plasma cutter.

 

[GuntherRommel]

Nice