Where to get u bolts for 105 bed bobber?

[cookeemann]

At the risk of being Mary Kayerized for asking, can anybody tell me where to order u bolts from since I'm on the other side of the moon in New Mexico and not anywhere near a "spring shop"?

I searched "u bolt source" and came up with how to install a gun ring and reinforce your frame but after 30 minutes I'm tired of trying different creative search inputs.

I know it's out there but don't have lost my patience wading through all the other "stuff" to find it.

And square steel stock - 4" - is what's normally used for the lift blocks, right?

Very Humbly,

Cookeemann

 

[swbradley1]

Are you looking for new or old bolts?

 

[blackrock]

I can have them made and shipped out for you. thanks kyle

 

[cookeemann]

Thanks for the replies guys. I''m not picky. New or old serviceable are the same for my bobber, long as they'll work with the axle and 105 springs.

Thanks again!

 

[eldgenb]

any local truck shop will have a pretty good selection, almost all of the one's in my area will make them to your order. 3/4 inch stock 2.5" inside spread, square ended U-bolt and just measure your length.

 

[jimh1985]

truck and trailer here in macon GA can make them im sure they can ship them to it cost my 95$ for all 4

 

[mikew]

www.truckspring.com

 

[cookeemann]

Whew! That place is expensive....

 

[mikew]

About $35 per u-bolt "kit" (that's a pair of u-bolts).... that's one of the better prices I've found.

U Bolts for Trucks and Trailers, U-Bolts, UBolts, Square U Bolts - TruckSpring.com

 

[HAWKMAN]

If your looking for U-bolts from a 105 trailer I can do all four with nuts and top plate for $60.00 shipped to your door. PM me if interested....TXs

 

[cookeemann]

Nah, I needed some for the Rockwell that would accomodate the lift blocks necessary to bob using the M105 bed.