Recent content by Isaac-1

You can be surprised if you want, I have tested it connected to my 12V F250, though only in nice weather.

I have a MEP-016D and as I recall the entire 24V electrical system consists of the starter, which will generally have enough excess power to crank on a well charged 12V battery. There is no onboard alternator or magneto that charges the cranking battery, unlike the MEP-016B, etc.

I have a MEP-003a about 10-15 miles from you (in a shed on the family ranch on Hwy 26 about 10 miles east of DeRidder) doing the exact same thing, I have a spare injection pump for it, just have not found time to get it installed.

Well the power is back on at my house, it came back on at about sunset last night, we are some of the first in town to get power, as we are in the old part of town on the same section as the downtown government buildings and the hospital. Basically an 8 block by 3 bock area in town got power...

I am on CLeco, but lots of the surrounding area is on Beauregard electric including several of my relatives, last I saw earlier today BECI is estimating a minimum of 3-4 weeks for service restoration

Where are you located, I am also the Laura outage area, and have a MEP-002a that got clobbered by a tree as well as a MEP-003a. Dealing with lots of issues here at the moment, for ourselves and family with generator, roof, and other issues, but I might be able to help if you are nearby. I am...

The MEP-002a was the primary backup for my house, I also have a MEP701a which will of course not run as much, though I am not using it yet, as we bought a motorhome about 4 years ago which has an onboard 4000 watt gas generator, so we are living in the RV in the drive way for now. Water is back...

Glad it is working out for you, we are on generator power here in DeRidder also, unfortunately my MEP-002a got clobbered by a falling tree crushing the louver box and cracking the head. Thankfully I have other generators, also it sounds like we are starting to get power back in parts of town in...

Well the injection pump is the least of my problems now, anyone know where I can get parts? exhaust header broken off the engine, broke the boss off the engine which i hope can be welded back on and retapped. Thanks for any help on locating parts, no telling how long we will be without power here

The best thing I have on hand is probably ATF fluid

Will do, but it will have to wait until the storm passes, it is starting to get breeze here, though not too bad yet.

I just went out and had my wife crank the MEP-002a while I watched the plunger, the solenoid lifts up while cranking, but the arm on the side of the injector pump does not move.

Thanks, I have already seen that, just don't have a clue how to interprit "14" stamped in to the right flange, is that mm inches, etc? p.s. trying to get done boarding up doors, etc to get out to check the linkage for movement

I will double check before pulling it apart, but I am getting fuel to the injector pump and nothing coming out of it.

Well when it rains it pours, literally, we have a Cat 4 Hurricane on the way scheduled to be here in the overnight hours, and now my MEP-002a will not start. It ran fine when I last started it a few months ago, now it is not getting fuel to the injector pump. I have a spare new in the box...