Recent content by JamieM1009

Knocked up these two parts over the last few days, as you can see the old fuel inlet cover was rusting away and the mount for the water can was none existent. I think my replacements are pretty good.

Yeah just the filter, gasket and it comes with an O ring for where the filter goes on. I'll catch what comes out and try to put the same back in then start it & see how it goes. The transfer case always ran well and doesn't leak, just thought I would do some maintenance and change out the fluid.

Ok thanks, just order 20 litres of Dexron 3 so I have plenty for transfer and transmission . When changing the filter on the trasnsmission, is it just off with the old and on with the new then refill of is there anything specific you do? I take it you fill it from the dipstick? Can you check the...

Can anyone confirm exactly which atf fluid goes in the transfer case. There's 4 or 5 different atf fluids, each with a different letter after it. also exactly which fluid goes in the transmission? thanks

I believe the horn has been rewired on to a switch in the dash, so that's sorted. As there's a few lights not working on the dash we can pull it out , replace all the bulbs and check all the connections at the same time. Personally I think the leak on the np208 may be from the breather at the...

Looks a peach! we'll get to work on those little faults, shouldn't be anything serious. Did you clean the transfer case?

New uj arrived yesterday, correct one this time. All fitted, a little stiff but can be moved by one hand. Just need to give it a run out.

Thanks all, will try and give it a run out asap just to see if my other issues have cleared up. Will take it easy on the gas!

I looked at a friend m1008 today and it looked more like the one for his. I've found what I believe to be the right one just wondered if these uj's are ever prone to breaking . Now I've refurbed the old one it must be better having grease and some bearings in!

how likely is it to snap? Leaving me stuck.

Hey So i ordered a new UJ from rockauto, thinking it was the right one but when it came it was too big and due to the postage costs from the UK its not worth me sending it back. Trying to be resourceful I cleaned out the cup from the old UJ that had no bearings in, greased it up and took the...

Hey, I checked the bolts and they were all tight, nothing loose there, which I was glad about.

Ok so found a big piece of something inside the muffler, probably the stuff that absorbs the gasses, that would have been the rattle. Checked the UJ at the drive shaft to rear diff and it was totally dry and wasted. Only one of the cups that goes under the bracket part had bearings in, the other...

I haven't but I refilled it about 18 months ago so should be fine. Worth checking though.