Recent content by lindsey97

20lb. C02 bottle with regulator.

Y'all should be able to handle this one...……. Purchased a 27.5" mountain bike on ebay, seller can ship, but I wanted to see if anyone was headed south thru Iowa and could move this closer to me, or possibly deliver to me for fuel money. Tires come off without tools, and it only weighs 32 lbs...

Haul anything I can get in the bed. This was a sewer line project that I completed in Spring of 2017, 2200 feet of 8" SDR. If I can ever get anyone to build me a set of ramps that are easily dealt with by hand, I will haul my Jeep TJ in the trailer, and dirtbikes/Yamaha Grizzly.

I bought one of the pyle converters, input is from my slave plug on passenger side with long power cord to the pyle. Output is a 12v cigarette lighter plug with 6 ft. of cord. Mine was $17 on ebay, but is only 5 amps. All I plan on powering with it is charging my phone, or powering my Garmin...

Oh Gimpy you went and stepped in it that time.....I'm gonna tell her.

One thing for sure with this situation: Nice guys finish last.

Probably the fuel line in between the filter and the injection pump. Will not show leaks or wet spots. Will lose prime, not start, and finally won't run. The line dry rots, has very small cracks, which allows air to enter and the system won't stay primed. Replace the line.

Hope you get to go home soon and are feeling better. God bless you Guy.

Guessing the bridge is still out. We may have a truck on towbars, good to know.

Read all 9 pages of this thread. Got me interested in the Milwaukee fuel series of tools. Have seen a lot of 1/2" fuel impacts in use and everyone raves about them. Couple years ago, I bought a Dewalt 1/2" impact and a Dewalt cordless 18 volt grease gun, since I already had Dewalt 18 volt...

There may be a thin brass adapter/bushing to make different sizes/style of cable compatible. did it fall out, get left out at pump shop, or is it stuck on the end of your cable?

Probably a 1/8" or 1/4" npt scrader valve. Take assembly to a plumbing store and figure out thread size. Looks like 1/8" npt. Then get on ebay and order correct scrader valve assembly in stainless. They make brass or stainless. Same part as on a paintball tank, scuba tank, or dirtbike shock.

Feel bad for them. Appears to have been an A2.

Allison C-4 rated oil which is 10wt with correct additives. Oreilly's premium green bucket 5 gallon pail, pn 74209. Plan on needing more than 4 gallons or whatever the dash placard says, they didn't take into account for the cooler, hoses and filter capacities.

Take your external filter off (the one under hood passenger forward of trans). Cut it open and inspect pleats in filter for residue/debris. You can also send a fluid sample off to be tested for content and condition of fluid. It's most likely the clutches if Allison has tested it. The...