Recent content by michaelpilot1

The A3s are just updated A2s they share the same Rockwell drive axles and hub assemblies, the A3s have added air fittings and different bearings/seals to accomodate the auto tire inflation system. Yes the A3 rims will fit the A2s.

Bearing in and alternator quite. The front bearing on my AMA-5102UT Prestolite alternator ended up being a 6304 Timken by the dimensions, a local company had a Koyo bearing that crossed over. The original bearing had no makers marks or ID marks of any kind and was not a sealed bearing, the...

M35A3 with 395's

Has any one tried to replace the bearings on the A3 Prestolite Model AMA-5102UT alternator on an A3? If so do you have the part numbers for the bearings? The TM parts manual 9-2920-225-34P does not show the bearings although the dissassembly procedures shows them.

I have 395's on my A3, the CTIS has been removed, the wheels turn so slowly at the speeds we can run that they don't really need balancing. I run 45psi on mine but would probably be fine at 35 since at 45 the outer edge of the tread lifts slightly off the pavement.

The piece on the front of the fan is an air powered clutch mechanism that unlocks the fan and lets it freewheel when the engine is cold and locks the fan to the hub if the engine reaches a certain temperature. According to the tech manual, if it freewheels with no air pressure to it there is a...

Home safe and sound, took over 2 hours to pressure wash the deuce.

Put me down for one XXL and one small gray. Thanks

A3 to A2 bearing conversion The A2 bearing conversion kits are available at Memphis Equipment Co.(great service dept and fast shipping) in Tennessee the rear bearings are a remove CTIS air manifold and install new A2 bearings affair. The fronts bearins require the replacement of the A3...

There is no park provision in the Allison transmission and the truck will roll freely in any gear with the engine off. The adjustment procedure is located in the A2 maintenance manual section 8, the incab adjustment is for cable tension. There is a clearance adjustment on the shoes at the rear...

New to the ralley, planning to attend and bring my A3 and camp, do I need to make a reservation if I dont need electrical hookup?

Do you remember the NAPA part number for the seals, I am getting ready to do mine?

I just picked up a 105 trailer and want to pack the bearings, did you come up with a part number for the seal?

The maps look great thanks for doing the work.

michaelpilot1 Mike Smith Kennesaw, GA 30144