Recent content by papa8856

Hi guys, I can't find anything about the problem I'm having. Please give me any suggestions. When my truck is parked on level ground I have a oil leak about 2 inches in diameter in a couple of days. But when I park in my driveway with a slight incline it doesn't leak. Not one drop. Could it be...

Hi Looking for a little help. I just changed my glow plug temp sensor and I can't get it to stop leaking. I used Teflon tape on the adapter and sensor since the adapter came out with the sensor. Is there an o ring that goes around the adapter? It looked like there was one so I put a thin o...

I do have a spin on filter Thanks

I changed the bulbs. I have to check for voltage tonight Thanks

Good morning I have been trying to troubleshoot why my wait light, and water in fuel light don't come on when starting my m1008. The truck starts OK. I have checked fuses, Glow plug card, and glow plugs. My question is I have attached a clamp on amp meter to the glow plugs. I think I did this...

Yes sir !!!

:lol:Cleaned the ground and reinstalled. Traced wires up to steering column. Found loose dark blue wire and loose light plug wire Shook them and the directional started to blink Yahoo!! Also cut the diode out for the horn, spliced the wire that someone had cut by the horn. Now it Works !!!!

Thank you for your input. I changed it last night I have 12 volts at both silver prongs at the bottom of the socket. At the same time I don't know if this is correct or not. I have to chase some wires tonight. I will check the ground again.

Changed Front and rear Differential oil Changed Transmission filter and fluid Drained transfer case and refilled 4 new shocks installed Changed glow plug relay Changed fast idle actuator And Still troubleshooting my right front Directional ( inop)

Welcome cool bike !!!!

Changed all Belts, Changed all power steering hoses, Installed correct oil filler cap, replaced crankcase valve. Still a work in progress LOL !!!

Hi all, Thank you for letting me join the site. I'm excited to get my CUCV M1008 Saturday. I looked at it last Saturday. But didn't pull the trigger. I thought 4700.00 was to much to pay. So I contacted him again, and we settled on 4300.00. The truck is rust free and it runs. I have a question...