Recent content by v8jeeptj

I never had heat it blew cold when I got it. I will try to manually operat the doors. How do I go about bleading the air out

Heater blows luke warm air. Just installed a brand new thermostat and both heater hoses are so hot that you cant grab them. When I cycle the swithes in the cab they all seem to work fine but no heat. Any suggestions

I think you answered my question, so I can tap into this for my oil pressure guage?

Is this for engine oil or transmisson? Should oil flow from it when the valve is turned or does the motor need to be running?

When I pop the hood on my 1009 there is some type o bleader valve mounted to the side of by coolant resevoir. It has a chain attached to it and appears to tap off of some type of coolant line that run up to the cooler mounted to the radiator. When i followed them back they seem to attach just...

Anyone have detailed instructions on installing zero rates? Pictures would be good as well. Searched but only found 2 threads that did not help much

Just picked up my wheels and was wondering what lugnuts everyone runs? Will the 315's fit stock How much needs to be clearanced for the rims to fit? I planned on using a handheld router, is this a good idea?

Thank you for all the quick responses. I decided to put the install off till this weekend and order the correct gasket.

In the middle of replacing my IP. I just opened the intake gaskets and the new ones do not have the metal block off that covers up the hole for the emissions. I think it is a mater of a J code or C code motor. Can I still use these?

Does anyone have a part number for the IP gasket where it mounts to the engine block?

Thanks for the info, I just removed the oil fill tube. Once you get the bolts loos put your finger through the hole and hold the bolt into the socket as you pull it out.

Just got my IP removed and am getting ready to ship it off to have it rebuilt. The process was not that bad but acutally taking the ip out once all the lines and bolts were removed was a pain in the ass. I do have a couple of questions. 1. People that have done this in the past do you remove...

Thanks for all the help. I will look into it this weekend

The throttle is sticking on my truck. When I drive down the road and left of the gas it seems like I am on cruise control. I can put my foot around the back of the pedal and pull it up but it stills stays ideled up. If I leave my foot off the gas it will eventually come back down. When i hit the...

Do you think I have a IP problem if when I hit the throttle pedal real hard sometimes the the throttle gets stuck wide open. The spring on the IP snaps back as normal so I dont think the cable is getting stuck. To get the idel back down I have to go crimp the fuel lined then the rpms drop down...