• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

 

Recent content by WARWAG

  1. WARWAG

    M1010 will not start.....

    Well my starting issues are a thing of the past. OK here's what happened from beginning to end roughly . Went to Napa to get a new glow plug solenoid. I believe they gave me the civilian version. (My fault). started having cold start issues and the front battery getting low? Something to...
  2. WARWAG

    M1010 will not start.....

    Great idea. I will add a few additional grounding wires/straps. Thank you.
  3. WARWAG

    M1010 will not start.....

    Bone dry.
  4. WARWAG

    M1010 will not start.....

    I hooked everything back up and went to both ends of each side of the glow plug harness. Each side reads 24 volts when the glow plug is cycling. Isn't the card supposed to regulate it to no more than 16 volts? Well my new card from Hill Billy Wizard isn't. Need to have a word with them...
  5. WARWAG

    M1010 will not start.....

    OK here is the latest. went out and checked the voltage going to the Relay. Its 24 Volts. Not 12 but 24. I disconnected the relay wire on the 24 volt block going to the resistors and just ran 12 volts straight to the glow plug relay. Measured the voltage to the glow plugs and its 11.98...
  6. WARWAG

    M1010 will not start.....

    I will check first thing in the morning. Thanks.
  7. WARWAG

    M1010 will not start.....

    Will check and see if the bleeder valve spews diesel out when I get home. Last night I went out and looked at it and the two wires coming from the top of the fuel filter manifold (red and black) were completely chewed through. Are those for the "water in fuel" sensor?
  8. WARWAG

    CUCV M1009 electrical issues

    Before you adjust your shift points do this. Go under the vehicle and look up on the passenger side of the Transmission. You will have a shifting modual on the passenger side of the trans with about a 1" length of rubber hose connecting to the trans. When that hose gets old (80s vehicle) and...
  9. WARWAG

    M1010 will not start.....

    A few months ago I ran into a strange issue. When I would start my CUCV I would smell an electrical burnt plastic smell. I knew instantly it was my Glow Plug card. So I disconeected it and continued on my daily travels. I parked the vehicle and pulled the card. No issues except every time I...
  10. WARWAG

    M1010 Lift Ideas?

    For the Dana 60 rebuild. This would be the perfect time to throw in some 35 spline outer shafts.
  11. WARWAG

    Project m1010

    Hi Guys and Gals, Well the beast is in need of some repair. Trying to recover my buried to the frame Campulance in mud with 150 of combined straps and Bow shackles. Well one of the 20,000 lbs rated straps broke and sent a bow shackle clean through my left rear door. The door was caved in and...
  12. WARWAG

    Modern Russian Army in the photos.

    I hear they are looking for Submarine Techs........
  13. WARWAG

    Project m1010

    Ive been to the junk yard several times trying to find the TV Bracket for someone. So far I have not found a one. I will keep looking. If I find two I will let you know.
  14. WARWAG

    Project m1010

    Actually the 700R4 has a lower first gear (lower than the 4l80E) and I must say it has greatly improved the in city driving. You are correct about the Overdrive issue without a turbo. It definitely needs a turbo. Step Two.
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks