Search results

well if its just the heater core you want to fluch i will tell you how i do mine, disconnect both sides of the heater core and cut the end of a garden hose off* the male end not the female end* and hook it to the inlet side of the heater core and turn the hose on. if theres a blockage it should...

check the relay under the dash its a silver metal relay cost about $20 here

yes very normal for filter change, when the filter in a diesel is empty i causes and air bubble in the system it causes an airlock in the injection system which stalls the engine so the system needs to be primed after filter change

u joint souinds like, mine did that till i replaced them and viola noise gone

loose or broken bolts, missing support bracket, faulty re-manufacture.

the top of the filter block is a blac kplastice thing close to the pasenger side of the filter base unscrew and remove the PINK wire from the top of the injection pump then crank engine till no air bubbles come out of the nipple on the top of the filter base. then tighten black plastic screw...

my heater was about $65 CAD

i use a 1500w circulationg coolant heater in my m1009, installs in about 30 minutes on the one side of a the heater core hoses

check the IP around the throttle shaft for leaking then check the fuel lines in around the filter to the ip

i run my m1009 as a daily driver, grocery getter, and everything else. it is defintly loud especialy witht he cherry bombs but its gives me a both the family vehicle as well as a tough mean 4x4 with crappy gearing lol

RE: Re: RE: top speed for m1009 i have lined up the speedo needle with the middle of the odometer going down a back country dirt road for a total of 20 minutes, on the highway average it around 80mph

if it has the th400 which it should theres a vacum modulator on the passenger side of the trans that has an adjustment screw in it to adjust shift points,

RE: Re: RE: odd steering noise i bet a set of IR lights the bushins on the front of the front leaf springs are so badly worn that when you turn your wheel the axle shifts and the leaf eyes clunk when they contact the mounts. i k now this cause mine do the same

CUCV( suk-v) cucv( chuk v) in my case the green meanie hehe

add a leaf is your best budget option, whatever you DO NOT put blocks in the front

RE: Re: RE: my first CUCV m1009 has some problems need some its hard to tell without getting right under there and looking but the "ears on the engine side of the mount look like the are lower to the ground then the base of the mount then your mount is likely shot. as for the cold i am candian...

RE: Re: RE: New Guy Reporting In welcome aboard

Re: RE: Steel Soldiers 2009 Florida Rally... Its on! if we can make it we would be coming down the east coast from maine, as we are in nova scotia

Re: RE: Steel Soldiers 2009 Florida Rally... Its on! if you want to come get it i got just over 1000gl's stashed hehe i been hording it in hopes the mrs will let me by a duece hehe

if my budget and better half dont mind, you guys just might have a couple of maritime canucks down there