Search results

Same here, picked up on 2-2-22 from mclb. "It's in the next batch."

I had this in my 1152 and the four wires ran to some type of fuse block behind the starter and on top on the frame rail. PIA to remove.

For the 6.5/A2, OEM for me... https://genuinehumveeparts.com/product/5743238thermostat-65 cheaper at macs https://www.macmotors.com/Product/HUM/5743238

A couple hours sitting in the seats, not bad.

For me it was a bad cartridge seal. Excessive oil in the intake + compression in the crankcase. I pulled the turbo and leak tested it with water. The water freely flowed through the seal to the oil passage. $150 part

I just picked up another 40lb's of sand from Barstow Friday. I started with my shop vac followed by four sessions with the pressure washer. I am doing open heart surgery tomorrow to find out what's making my turbo sick. Then off to the machine shop!

Released today!!!!!!! M1152 won on 9/8/21 2nd Euc submitted in last 2.5 years on 9/10 9/15 submitted to TSC

The 1151 picture was from the web of the part I need for a M1152. Thanks

Are they threaded or just a spacer?

That is exactly what I was looking for so Thanks! Is that just a spacer for the b pillar so bolts can run through without crushing or is threaded? Any idea the NSN or where I can get two? Thanks again

We had one up here at the MWTC where a M1151 went over in a ditch during daylight and killed the gunner. Tragic and preventable!

I was told to be careful as the truck can't be replaced as fast as Marines can!

So I went ahead and ordered the above pictured stiffeners for nothing else than to get the interior rivet pattern. I may end up drilling the hinges to fit the old pattern if it's off. I have all the parts except glass and b pillar reinforcement to complete these doors now.

These doors have the bend and fit perfectly. I plan on fabricating inside channel blocks with bungs unless I find something already built. The above pictured spacers appear to me that all of the notches are to clear the rivet pattern on the inside? I may buy those and mod them if necessary...

After searching all of the parts TM's, I am unable to locate any diagram that shows reinforcement on the body side for piano style hinges. Can someone point me in the right direction in the TM (body side reinforcement) to mount heavy doors, share some pictures, or a source for parts. I found...

2nd EUC in last two years?

Yes, did a AM General/pick up about two years ago with no issues. S.B. 356 passed and allows for the titling and registration of “retired military vehicles".

I see the part numbers but what are they for?

M1152 won on 9/8/21 2nd Euc submitted in last 2.5 years on 9/10 9/15 submitted to TSC waiting...

More photos of the doors from the internet, old auction.