Search results

I see a wing nut?

@Nico good pic's and looks like a good time.

This Is not going to go over very well with the wife when needed, but honey I read It In Steel Soldiers, sure you did, really I did, some guy said you just have to put your hand over that hole while I crank the motor. I see this conversation in my future.

Welcome from raining south Florida.

http://video.search.yahoo.com/video/play;_ylt=A2KLqIL.fvRRclUAnon7w8QF;_ylu=X3oDMTBzZnZtb2xyBHNlYwNzcgRzbGsDdmlkBHZ0aWQDBGdwb3MDMTM-?p=install+gov+lock&vid=012bc3686df0d157d140765b0357b45a&l=9%3A43&turl=http%3A%2F%2Fts1.mm.bing.net%2Fth%3Fid%3DV.4724963358015800%26pid%3D15.1&rurl=http%3A%2F%2Fwww...

I don't have a Pic but your hinge should bolt to a support under the bed pan In the rear. This Is a spot where a lot of these trucks rot away. If you go to LMC Truck Chevrolet Blazer PG 40 Bed and Tailgate Supports you should be able to rebuild this area If needed. If you Google K5 Blazer...

That Is a lot of support brackets? I would love to see the suspension to see what kind of weight Is was designed for. Trailer looks small though, :popcorn:

Truck looks good.

I have been using nothing but the Google search on the top of the page lately, It Is a lot easier than going straight to Google site and has been working good for me.

Welcome from extremely hot Dania Beach FL.

A boss once told me there Is no such thing as a "STUPID" question. Especially about a special tool to open a standard slotted ball valve that any soldier or civilian can open or close with a crescent / adjustable wrench. As per your not so stupid question. In TM 5-6115-585-12 4-5 special tools...

All my gen oil drain valves are ball valves that have a handle and some don't have a handle, the ones without the handle only need an adjustable wrench to open, Please show a Pic of what you have.

A transducer is a device that converts a signal in one form of energy into another form of energy. "WIKI" I know the transducer input Is 120V. what am I supposed to get on the output side for the test purpose. And I figure once I know that, I can also test the HZ gauge by supplying the gauge...

OK, I am feeling like my left foot Is nailed to the floor. I have searched, searched, and done some more searching on how to bench test the MEP-002 & 3 frequency gauge & transducer. Can some one guide me In the right direction to find this info or does someone have a step by step guide on how to...

This thread Is like a BIG fish story, really I did catch one this longgggggg. :roll:

I just removed the existing pintle and cut in and welded a 2" female receiver. Now I can use a pintle or ball In the existing space. It also keeps the receiver the same height and not below the bumper.

Hint to GL. If your selling a product or products and you want the best price for your product, you would think you would bend over backwards to provide the best customer service you can. For all my experience with GL or GSA over the years, I will have to say I have had nothing but friendly help...

I can buy a running 6.2 for that price....

Nice Job.....

Welcome from Dania Beach.....