Search results

OK, Unless someone objects I will install a 3 amp fuse and try again. Peter, Which test you want me to do first. Kris

Yes when in the start position 100 volts on the control volt meter. Then in the run, no volts

Was going to video the startup again and checked the 1 amp fuse going to A11 new transformer. Blown Should I put a higher rated fuse? Kris

Started up the gen. No volts and no HZ. Been talking to Peter and we going to make some tests. The good thing so far is no smoke:smile: Kris

I'm connecting the ground system. Rod is in the earth. Connected rod with bare wire to outside frame. Should I connect to L0 also? Kris

So you want me go thru all the settings in the video? Kris

Good, I have two settings mV and V So I will set it at V Now I just have to find enough guts to do it. Ill have a friend video it. But I did not recheck the config board. Kris

Here in texas we keep all the rain (40 inches in 48 hours). Kinda stingy. But I don't think you want to have 4 feet of water in your house. Even though the rain is gone up to you, the streets are still flooded and some of the schools are still closed. Why people move into flood potential areas...

I'm setting up for the start up test but don't know how to insert a video. Kris

The readings are as follow: full to left 14.0 ohms midway 119.0 ohms full increased 244.0 Kris Had to wait for the monsoon to stop.

ok

No Now I have one set of wires fused and the other set fused. The first set was from one diagram and the other from the new diagram. Kris

If you need more views just tell me. This is the A11 Kris

Ok that will be easier. So I will be taking pics tonight after I eat. After that in the morn I will post the prelim test before I install A11. Kris

I have one set of wires left to install on the trans. It has the fuse holder that was installed on the other trans. Question: If I put a 20 amp fuse in the holder instead on cutting off the holder could I use it as is? Correction the largest fuse I have is 15 amp. That would be H2 terminal #2 Kris

I am still wiring A11. This so far it took a 6 pack. Also Houston is flooded big time. Glad I moved out of Houston 40 miles North. Fuse holder is installed, but if you put it between the J connectors which I did, you will have a hard time torqueing the holder so it will be tight. When I finish...

I measure resistance of R2 before I install A11? Kris

Peter, Is there anything we should test before I install the A11. Kris

Will finish installing the transformer today plus the fuse holder where Guy suggested. Had to drill some holes for the trans and the trans because the holes were small. Kris

I fused between the trans and the two wires X9Z and X9W that were spliced together when I shipped it to you. The diagram for the PH250MGJ denotes to fuse X12JJ and X12KK Spliced wires to go between the trans and the spliced wires. So the fuse would be active on the H2 circuit per the diagram...