Search results

Ok will do but the hard line opposite from the injection Pump is very hard to get to. So if it is free which I think it is, only gravity feed what would be next? The valve? Kris

OK Pumps running fast and then slow with the float out and unplugged electricity. Connected the connector to the float and float just hanging outside vertically and pumps never slowed down and filled the day tank. Started cracking lines all that I could and getting good flow except through the...

Here is the float pic

Tested the float per your specs. It has two floats. Everything works like your troubleshooting. Kris

Got her unscrewed. Inside looks clean. 3/4 full. However just for the **** of it I turned on the battle and run to get the pumps working and they started without the float installed. Also looked inside where the pump input line enters the day take. No fuel entering the tank. but when I drain the...

Will be trying to unscrew the pipe threaded part in an hour. Kris

Ok so I will unscrew the NPT. I will let it soak over night. The best even better than BP blaster is 50% acetone and 50% automatic trans fluid. Cheaper too. Kris

Repeat this test, with S2 on and S7 on. We are losing VDC someplace with the battle on and the run on both #9 and #7 gets volts. Kris.

I tried with a four foot cheater to unscrew the NPT pipe thread and it is still very difficult to unscrew. Got maybe a 20th of a turn. Kris

Having difficulty taking the float out of the day tank. Unscrewed the connector. Then unscrewed the four bolts that held in the other side of the connector, but it does not want to come out. Do I have to unscrew the approx 2 7/8 pipe thread to get the float out? If so it will take a long time...

A4 card with run on pin 7 has power pin 9 no power

Tapped on the day tank and it seems to be 1/2 to 3/4 full Kris

The pumps only run when the battle switch is on. only tested this in run and battle on. Turn battle off pumps are off Also you cannot crank the engine when the battle switch is on. Wont turn over the engine. Will have to check the rest tomorrow. Kris

Just found this. Two taped wires V64F and V65P. This doesnt look normal Kris

Just checked which S2 wires gets hot when switch is in the run position. P45A & P45B. Kris

OK with one brain cell left in my brain I tested again with the run switch on. The other was the switch in the off position. I got the same three hot on the top and one on the bottom. Please look at my previous posts because I got several since you went to bed. Night Night Kris

I could not see which was pin number three but I got 24 volts on the top three connections on s2. Bottom set no volts Kris

OK found S2 the run switch. Will check it next. Sorry to keep you up late. Kris

No power going to A9. Where is S2? Sorry I dont have these memorized. Kris

OK will test and get back to you young man Kris