Search results

Sorry the top left corner Kris

From what a gather the top right corner is the low oil pressure light on the fault indicator. Also it should light up as soon the run switch is activated. This is why I'm saying it is not lighting up. Kris

When I push in the over speed switch (S9) it depresses and it springs back out. Is that what it supposed to do? Kris

S2 in the run mode. absolutely no lights come on at the fault indicator when I use the test switch. I haven't tried to get the bulbs out yet but I did switch a good bulb into the low oil pressure station. Kris

I jump the IP wire to the batteries? S9 is the speed switch correct? I set it a couple days ago. No low pressure light on when the switch is in the run mode and I used the test switch and no lights. Yes I tested the fault indicator with a 24 volt power supply. I discovered two bulbs were burned...

Cranked the engine and no volts to P8ON. Kris

Tried to start the engine 3 times for 15 secs at a time. It cranked pretty fast, but no start. What would you advise? I can crack the output of the fuel injection pump to see if I get high flow. Also if you see in the video Chad put some jumpers to the fuel injection pump. Will wait until you...

Tested the flow going to the injection pump by loosening the input line. Got flow. After a little while the pumps started running faster. Also I disconnected the top hose on the day tank that goes back to the main fuel tank and nothing came out. As soon as I install the ground rod I will try to...

Im sorry I misspoke about the panel lights. The panel lights work, but the fault lights do not. will check the lines and if flowing I will try to start the engine in the couple of hours. Kris

This comes to the big unexplained question. Why does the pumps just now started working? Is it because the unit has been setting so long and me flipping the switches and they are knocking off the corrosion? We have not replaced anything. Murphy is laughing at me and I don't like it. Like I say...

Also still no panel lights but the battle light does come on now when you flip the switch. Kris

OK, But at this time they have been running total 15 minutes and no slow down or stop. I will continue tonight but I think there is a lot of air in the lines and maybe needs bled. We will see tonight if they get slower. I think they are already slow and the air needs bled. Also i think the day...

Didnt see my other post so I will doc it again. Both pumps are running. Unplugged them one at a time and plugged them back again. Kris

Also the pumping clicks seem to me slow both of them. Kris

The pumps so far ran for over five minutes. How long do you think they will run to fill up all the reservoirs? I'm reluctant to run the pumps over 5 minutes unless you say it will be OK. Kris

OK young man. LOL

For the first time now I heard at least one pump working when in the run position with battle start on. Now no battle start light on when the switch is turned on and still no panel lights. At least we are going forward. kris

So I can call you "young man" LOL

Me too I was born in 51. R&D all my life. Kris

I will check again on whether the lights on the fault indicator works now in one hour after i cool off. Man it is hot here. But the battle light lights up whether you push the battle light button also it will light up when you flip the toggle. Kris