Search results

What I mean about energized is when I flipped the battle switch the light came on. Kris

Checked voltage to the upper pump. easier to get to wire. No voltage with run and battle on. The battle light came on when energized. Kris

Found the day tank. Tapped on it and it seems to be almost empty. Kris

So there are two tanks? One a day tank and the other that consumes 15 gallons? I will look at the pdf that you are pointing to. Kris

Sorry but I'm not used to some of the slang descriptions. For example on my H1 hummer there is a primary fuel tank and an auxiliary. Not a day tank and auxiliary. Kris

I can answer some of the questions but will have to check the unit to answer the others. 1. The tank has 15 gallons of fresh fuel. 2. I have to check where it is at. I havent changed any fuel valves. There is a valve on the side of the gen close to the fill port that says auxiliary, set tank...

It will turn over but the engine will not start. I believe no fuel because the pumps are not pumping and no sound from the pumps. Kris

Yes it will, but the last time I tried and it was the first time it took several toggles for it to energize the starter. Then several minutes later it turned over the starter the first try. Kris

Guyfang No pumps working. Kris

Gutfang, OK Got a question first. Since the A1 is wired correctly now and A9 is setting on my desk not installed: If I reconnect the batteries, push CB1, put S1 it in the run position, and toggle battle start I should here the pumps running if everything is OK? Kris

Guyfang Update A9 Fault indicator: All the lights are in A9. None missing. Fuse checked and was there in place. 1 amp and checked with multi meter. Pulled A9 out ready to check per the military manual procedures. ( Apply 24 volt to A+ and B- and use the Test or reset switch to see if all the...

Will do both you suggested. I will report back when finished Thanks for the reply Kris

Guyfang, I was able to see the schematic now and cannot see the wire number for N3. But I will check the rest. Thanks

I have downloaded the PDF manuals and starting to get acquanted to them. I am thinking to start with the Fault locating indicator and I see in the manual there is a testing procedure. I really need help and I appreciate your feed back. Please help me. Kris Church

Just bought an mep 004a and trying to start it up. At the control panel hit the run switch and no oil pressure light. No lights on the test switch also. The lift pump does not operate but I can jump it. I believe I can start the engine because there is a video of it running before I bought it...