Search results

Hey Rustystud, Your fingers look awfull young, you been moisturizing or something? https://www.youtube.com/watch?v=KCcckjGXNLc#

No. I find that a product designed for an application usually works better than one that's not. I have had experience with the brush / roll on bed liner and it's not even close to the professional stuff. Found it had a vary short life span for it intended purpose, would not wan't to trust my...

I used a roll on roof sealant after I calked and sealed the seams with RV seam sealer. The roof is aluminum. I have noticed a little moisture around the refrigerator. After some investigation it appears a branch hit the vent pretty good. Time to get out the extension ladder I guess.

That's a good idea. I will try it on one of the small doors.

Yes I would. It saved a lot of framing work. Now if I had deep pockets I would have built from scratch with fiberglass skins and a nice rubber roof. I am currently trying to find a way to get a smooth surface on the plywood siding so it will look more like metal. (At little or no cost)

Looks fantastic. What are you using to keep your drawers closed when going around corners?

Here is a slide show of the evolution of my truck. www.youtube.com/watch?v=_lLvENiLkjY Also a short clip of the roof top air running off the power inverter. This clip is part of video above. www.youtube.com/watch?v=ERfd59pgh-Q

Trimmed the front corners of the over head bunk. Have been using bed frames for the steel. Can get them for next to nothing and they are tempered steel. I need to get the plywood sanded and painted. Where it was sprayed with spray paint the wood is in good condition. Where it is just the...

yes

Wife says her seat is to hard. So I cut down the bottom cushion from a f150. Had to take four inches off the length.

Time to replace two tires. Might have gone a little to long but they are hard to get here in Eugene.

How much pressure do we need at the water injector nozzle?

How much pressure does the pump need. My truck being an rv I am wondering if i could just plumb into the fresh water system?

I wanted to use PEX but the cost of the fittings was just not in the budget. Went with CPVC instead.

I'm looking forward to this. I think that water injection will help us that burn used oil keep coke off our injectors and out of the piston cups.

Had a similar experience. It was my master cylinder. The piston was binding on rust in the bore behind the cup and did not fully return. A air bubble will not cause the brakes to drag as the pressure will just be released through the master cylinder to the reservoir. So most likely ether...

Yes it would and as we see in our own society it has. The point is if we are honest with our self's we have all done things that have had helped the decline along. In Gods eyes we all done things that deserve death. But because of what Jesus Did dying in our place we can have eternal life...

Pictures please!

It was the same back then. Under the law everyone at some point does something that would get them killed. It was to show that without a savior all you can look forward to is death.

I did. I replaced the outside aluminum skin with 1/2 exterior plywood. That's a lot more shear.