Search results

I thought that the brake combination valve controls this? It is located on the crossmember by the radiator.

Thats true most people dont know that you cant just hop in a diesel and expect it to start with giving the glow plugs time to warm up. They will just hop in turn the key to start and it wont they after a few seconds just give up and run away

That's cleaver!!!!!! They also make a switch with a removable key Dorman 85988 - Battery Isolator Switch | O'Reilly Auto Parts

You could install a alarm system that has a tilt sensor in it that goes if it is hit, they also have add on that can detect if glass is broken. But the lock cylinder should be enough

I had a problem similar, but the gasket on the master cylinder was bad and every time i took a turn fluid would come out. i got to the point where it was so low that when i took a turn it would cause brake fluid in the master cylinder to slosh to one side and sucking in a air pocket, letting the...

I like your the M1009 and I also like your tow truck. Is it a duramax?

I think it would be cool to have the toureet on a m10009 but don't f**k up as another top might be $$$$

I would get the ac's there are the best I have had these for a year now and not a single one has burnt out

DUCT TAPE just kidding but JB weld might work

I love those wheel spacers, They add a nice look to the vehicle

I got mine at LMC Truck i think with shipping and a gasket it was less than $10

I agree I would NOT install glow plugs from a company I have never heard of. If they swell it will be a pain in the a** to remove. I also highly reccommend the ac delcos I have had them for 1 year know and not a single one has swollen or burnt out.

I have used fram before amd don't care for their quality, I can bed the filter witout a problem and the insides arnt build to the quility I would like. I use the wix filter and their quality is by far the best their outside case is stronger than a fram

It sounds like a good idea if you need the extra weight capacity. It would be nice to level out the truck with or without a trailer. I don't know of a good company as I have never installed them. But you have the need for them it would be a interesting build. I would like to know more about this.

If its only working on high it HAS to be the resister, the high fan speed is the only speed that does not go thru the resister all the other speeds go tru that resister. I think it is attached to the blower motor under the dash. I could be a switch but 99% of the time its the resister. Good luck...

Looking good I would also love to see pics from under the hood!!!

Found out that my injection pump throttle shaft seal is leaking, so it looks like im selling the M1009:cry:

The frame has the usual rust but the rest of the body has no rust holes or surface rust except the hood has a rust spot less than 1x1 inch but other than that and the frame no rust

THIS IS NOT A WANT OR FOR SALE AD I want to sell my M1009 because the injection pump is leaking and i don't want to spend the money on it anymore. It has a new water pump, new lower and upper radiator hose, oil pan and freeze plug heater, new glow plugs about 8 months ago, new starter less than...

The block heater goes on the drivers side middle freeze plug i dont think it is the one leaking, this one is very easy to see from under the truck. I installed a block heater about 3 mounts ago and in Michigan it is well worth the time and money to put it in As for the leaking one you might...