Search results

My Truck tire dealer spun balanced my 9x20's for $20.00 each when I have them installed. No problems so far! Mike

It got reversed. They won't have to remove the tree's....

Its all about money and control...

Don't piss us off, as California does the rest of the country often follows! You'll get the trickle down effect. If you know what I mean... Mike

no good goes unpunished here....He should have kept it on on the qt.... To bad.

Can you get whats left out? If so call Memphis Equiplent on monday. They will have it. Mike

"Just needs a little body work and Paint"

Will, I went by there on Thursday on my way to a job interview in Rosemead. . Came back by there at 11am and they still weren't open. I wanted to check them out. Any chrge for admission? Mike

I change all the fuel filters about a month ago. Or 20 miles ago.. Mike

No, The hand throttle cable looked OK I haven't touched it for some time now. I had just done a foot in the floor boards run on the freeway for 15 miles. I'm going to check / adjust the linkages on Monday and lube them also. I degreased everything in the engine compartment a couple of weeks and...

I took the Deuce up onto the Freeway this AM. I went over to the tire shop to have a coiple of things done. About 28 miles round trip. @50 to 55MPH. On the way back as I'm getting off the Freeway the idle is @ 1800-1900 RPM. I goose it a little thinking that the throttle if stuck....No go. I...

I "googled" it thia AM. its for a M36 or a M46a1... A little longer than I need. Maybe I can trim it down for my needs....

What about NSN 2590-00-150-5768, part #10896678 for the rear harness for the M35a2 MF as per Saturn Surplus Web site?

I'm planning on replacing both my front & rear wiring harness. I've got all the parts/kits. I searched the site and this is all I could find. http://www.steelsoldiers.com/index.php?name=PNphpBB2&file=viewtopic&t=11264&highlight=harness...

Well I sure like the sound a lot better now. At speed I could hardly hear to the old jeep beep beep one..... Much better!

Well I put in my new air horn..... Nice and LOUD!... I didn't use any plastic. To much work and costs to reconfigure everything. Here's some pix.. Mike

Can you switch from copper to plastic without changing out all the connection points? The truch parts supplier says I got to buy all new hardware. I thought I could just replace the lines with the brass center piece insert , new ferrel and be good to go? Mike

I'm going to be installing a air horn I've got on my truck. I've got the t-fitting and extra fittings at my local trucks parts shop. It's got 3/8" copper lines on everything comming off the copmressor. I've got 3/8" copper tubing from the hardware store. Should I be using DOT approved plastic...

I looked at your truck....Not bad.

here's mine