Search results

My 1031 did the same thing , I had a bad starter relay (under dash) I just took it apart and cleaned it up , have not had that problem since. (I'm cheap I could have replaced it for under $25.00 but .....)

I got all mine through NAPA they looked it up to make sure it was right size and I just painted it green to match the Military look lol.

Here is what it looks like now, Got it all changed and working fine. Hope it looks good to you diehards lol

This summer I'm going to replace the tank and add a 2nd one on the Pass side, I allways disliked the fuel filter setup on the cucv anyhow, prone to leaks ect....

fuel tank has rust in it and filter drain / water drain leak (suck air) currently changing fuel filter about every 800-1000 miles, spin on cost $6.00 original 18 - 24 $. Spin no is easer to change also.

forgot to add I'll have a old fuel block with all electronics still attached to get rid of, the shutoff/water drain leak, need new plastic doo hickies lol

I'm changing my fuel filter Assy to the spin on type, question I have is other than the water in fuel light do I need to worry about the other sensors and heater? I hope not but had to ask....

My 1031 was bent with pass side dammage and fuel tank dammage. Just do not plan to drive them home when you pick them up lol

The civiy model is differnt though and the military one is no longer avalable through GM You have to either fix your old one, find a good used or surplus new one , change it to a civy one or put in a push button one ...ect....

I found mine in a salvage yard, matched size (within 1 in lenth ) and u-joints cost me about 3 +hrs time and 100.00 ish

I went from St Louis to Mechanicsburg to pick up my truck , I was late but called inrout , they were pretty nice there. I was just upset that they move thr trucks with a fork lift...... I was driving it back to Mo. Call early and GL

what modifications if any would I have to do to put hummv tires and rims on my 1031? or has anyone tried it?

Here is my old pic's didn't have a chance to get new ones yet

I'll post pic tonight, I need t take some new ones

I have a m1031 with the pto type gen in back that I may have to sell and I'm trying to find out how much it is worth or where I should start my $ quest at. It has almost 20,000 miles on it , no rust to speak of but is in need of some TLC due to forklift dammage and 3-4 coats of carc paint (last...

What is the correct sand color on the cucv, mine has 3 differnt sand colors and this summer I am going to repaint it and want it as close as possible to the correct color. I would rather camo it but wife said NO WAY to that so Ill just redo the sand again.

I hav d a few pices of 1/4 in aluminum laying around the cup holders are cake fosting tubs. jigsaw and drill is all it took lol

Ok i'll have to remember that........

How do I post them to the site for everyone? :?::?::?::?::?::?::?:

My 1031 brakes (front) drag some and the only thing that helps is I grease the rails (mounting ) for the calipers seems to stop it every time.