Search results

Agreed you shouldn't need/use tools, unless you prefer to jack the tire for installation. I myself rollover the chains. Get the inside as tight as possible and then pull the slack to the outside and clip. The problem is caming over the outer clip, often there is some slack remaining which is...

It is possible to install a tire chain assembly on any tire without a tensioning device properly however it's very difficult. The tensioner merely ensures a properly installed tire chain stays properly installed. Tire chains should also be checked ever few miles, particularly if you are on...

If I had a nickle for every tire chain I found incorrectly installed, I'd have a M1070.

missing the tensioner.

I'm leaving O'dark thirty tomorrow bound for Malmstrom AFB, Montana. Slated to return back to Minot ND on the 23rd of Dec. I have a Empty F350 out and back, can haul pretty much anything with my license but the truck has it's limits. I'll have all my hitches minus the fifth wheel. Short...

I got you beat. The recovery of My M915-A1 took me on quite the adventure. Minot, ND - Scotland SD Scotland, SD - Sturtevant, WI Sturtevant, WI - Dayton, OH Dayton, OH - Leesburg, AL Leesburg, AL - Chama, NM Chama, NM - Salina, KS Salina, KS - Stromsburg, NE Stromsburg, NE - Fargo, ND Fargo...

Matt, when I looked it up when I did my recovery the part number crossed to a ton of vendor's. I feel most of the lights on these CCC style trucks are "good enough" as far as uncle sam is concerned.

They are a commercial product, you can find them in the NAPA catalog.

My experience with the Mil fleet is Howes. However with my 6.4L PS and Howes may as well be water the only thing that I've not gelled up using was Stanadyne. Incidentally Stanadyne makes the ford additive. Power Service 911 is an emergency product, that doesn't work IMO. Howes doesn't back...

Hope you are safe, that should be the first question. Best of luck on the remaining trip.

My 12 volt draw is off an on. My 915 killed its batteries a few years back and then it was fine all of 2013, now it's doing it again. I haven't traced it yet but I have a feeling one of these day's I'll convert the whole truck to 12V. Wish I was closer Karl, then I could be of use. I have a...

I agree, slave and ether are the only thing that bring the NTC-400 to life when temps are that low for my M915a1. Just follow the instructions.

Pictures would help.

The prototype HML for Midgetman MGM-134 was bid by a few companies, unfortunately the CAT/MM version was didn't win. The wheeled version built by Boeing won out it was tested in Mt until 1991 when the MGM-134 was canceled. The HML like the Rail Garrison where canceled due to advances in the...

Nice work, I'm in the same field but this machine doesn't have any of my finished work on it.

I would but it's not done...

No nothing yet, I bid a big job and lost and have been trying to get winter prep done...with no success. So I kinda stopped working the deck. My ex finally paid me a large sum of money she owed me so that will help. I need some 300 bolts to tie the deck down which means 300 holes in white...

I called them, and went with my route...

I didn't read this thread but if it hasn't been mentioned ISIS has a connection to 11/11. Please celebrate with your guard up, the AT officer didn't brief us for nothing.

Taken is a relative term, I paid 3800 for mine but I think the bill after repairs service and recovery were over 8k, but my recovery was pretty unique.