• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results

  1. G

    Newbie Alert! New LMTV in DFW

    You fill through the dipstick hole. Get one gallon that will be more than sufficient.
  2. G

    1083A1 doesn’t run longer than 45-60 seconds

    Also the fuel lines on these are known to rot out and leak. My 2008 already had a leaking hose and the others were BAD with dry rotting and cracks. The outer rubber just falls off in chunks. Run your hand over them and if it comes off looking like black coal dust the lines are shot. Sometimes...
  3. G

    Newbie Alert! New LMTV in DFW

    There's a dipstick that unscrews from the air operated pump right on top. The suspension cylinders often leak also. I've seen that quite often.
  4. G

    Newbie Alert! New LMTV in DFW

    The MOST COMMON reason for nothing happening is that the system is low on fluid. Check the fluid level. Make sure you only use MIL-PRF-5606 in the system. They *can* operate on regular ATF if completely flushed but you need a system that's trying to work to do that.
  5. G

    Newbie Alert! New LMTV in DFW

    900 series A2 trucks had an early version of CTIS. The MTV replaced the 900 series 5 ton. M939A2's had CTIS and it was a real pain in the neck. Often disabled. The wheel o-rings didn't stay in place and they always had flat tires. I wouldn't pay more than $250 but I'm willing to wait for the...
  6. G

    Newbie Alert! New LMTV in DFW

    Actually any of the FMTV CTIS controllers will work - green or black. The bus is only used *if* you want to hookup the Dana software and they all have J1708 so any of them will work in that regard. If you want to use a 900 series truck controller you can - just have to pull the pins out of the...
  7. G

    LMTV FMTV Transfer case output seals

    That number doesn't cross to an NSN. What's your truck serial number?
  8. G

    LMTV FMTV front axle outer seal replacement

    1/4 socket extension or a large flat blade screwdriver works just fine. I've done 4 trucks worth that way. No leaks. Just use your brain and be careful. Seal drivers for this application are only for when you are going to rely on 18 y/o kids to install them and every problem is a nail because...
  9. G

    Newbie Alert! New LMTV in DFW

    Probably ill-advised but I had a bunch of people on speed dial in case I ran into anything and I'm ex-Army Motorpool and a master mechanic on the civilian side plus my Army buddy was a jet mechanic on A-10's before he switched branches. We ran into a couple minor things but made it back in one...
  10. G

    Newbie Alert! New LMTV in DFW

    Oh yeah. The seats SUCK and lack of AC.... Those two upgrades help a lot with passenger attitude. I rolled mine home 2,700 miles with an old Army buddy so we had no issues.
  11. G

    Newbie Alert! New LMTV in DFW

    No the data plates do not say A1R. They always say A1. A1R trucks are serial numbers starting at 100,000 in about 2004.5. All trucks built after the C7 change are A1R and were built by either S&S, Armor Holdings, or BAE. Your truck is most likely a BAE truck. They really cleaned up and fixed a...
  12. G

    Newbie Alert! New LMTV in DFW

    That's an "A1R" - get used to calling it that so people know you have a C7 truck when you are asking questions. They are quite different in a number of ways besides being very rare in the civilian world. Welcome to the exclusive club. What year and what is your serial number? Lots of people...
  13. G

    Eco Hubs 3.90 or 3.07 for Best Fuel mileage

    I'm not sure you would be able to really tell the difference. On perfectly flat ground, running the same RPM.... theoretically the 3.07 would have the advantage in terms of lower driveline speeds for the same road speed but may put you farther away from peak torque. If you adjust your gear/speed...
  14. G

    Eco Hubs 3.90 or 3.07 for Best Fuel mileage

    Probably very little difference in practice. Peak torque should be peak efficiency so the closer you are the better. Mileage depend on many factors. What was their speed? What was their tire pressure? Average altitude? Average temperature? Wind resistance? It can be pretty complicated. My...
  15. G

    M1078 no crank blows fuse

    Guys do like to disconnect the alarm buzzers - could be one of the wires wasn't properly secured and insulated.
  16. G

    Dual Circuit CTIS System

    Would be fairly easy to do since all the logic is in the controller and the PCU just has an extra control line. You would just have to add the control line from the cab to the front QRV and leave the existing line to run the rear axle(s). And of course any wiring between the controller and PCU...
  17. G

    What have you done to your FMTV or LMTV today

    You can replace the bulbs with LED's if you like. I did all of mine. This is just one example of many that are available: https://www.amazon.com/gp/product/B09SYPYWNY
  18. G

    CTIS - electrical smoke

    Wow. Just wow at the MME shenanigans. "They go through the truck top to bottom"....... my anus. Hub service IS PART OF the annual service on these trucks. I don't know how you can claim you have serviced a truck that hasn't had all the boxes checked on AT LEAST the annual service that the...
  19. G

    M1078 no crank blows fuse

    You need the A1 schematics: https://archive.org/details/fmtv-schematics-a-0-a-1-r
  20. G

    CTIS - electrical smoke

    Some of us just like gadgets and enjoy playing with obscure things that most people can't have. Also the system is fascinating in how complex yet marvelously simple it is at the same time. Don't try to make sense of it. It's the difference between jumping out of my truck to throw up the garage...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks