Search results

If you insist on running that switch, you need to hack those tabs off. They are there to space the lever type switch back further in the dash because it will be too close to the turn signal lever if it isn't. The push button switch is significantly shorter from its mounting plane to the top...

Who ever designed these things was a psychopath. Hard to use new. Need two hands to loosen when soiled. Break easily. It has more modes of failure than moving parts....which is quite an accomplishment in itself. And the strap is usually to wide to go through the stupid "thing" on the body and...

That's most likely. It was one of the many 2 door MAK trucks recently demil-ed at Yermo.

Probably easiest on top of the tank itself. Ive been really happy with the hand pump though . Priming has always been quick and easy.

Part number 12339620 About 18 bucks each new off ebay

Rusty cable on the right...

There is a drain bolt on the bottom of the fuel tank. Drain out the old fuel and add at least 15 gallons of fresh fuel. I recommend replacing the fuel filters at this time too. At a minimum do the secondary(fine) filter. The water separator is a plastic bowl under the primary(coarse) filter...

It actually attaches through the metal hood grille frame and fiberglass underneath . Not an issue at all.

On air brakes, the parking brake applies with strong springs in one of the sets of diaphragms the rear. When the engine is running and there is air built up in the system, when you "release" the parking brake with that yellow knob it actually uses air to over ride that spring and allow the...

My luverne brush guard came with cables that attached to the hood grille and held the guard upright when closed. When you opened the hood, the brush guard lowered itself as the hood tilted forward. I think they were repurposed from a slantback rear hatch. No rattles and super convenient.

HEE-HAW!!! You, Sir, are a card...and must be dealt with.

Besides the obvious NSN, and rebuild/paint date, Does anyone know the significance of the other markings? And, what would have been changed under the blacked out spots? P000 ? C/C-E- ? PRES. ? WR ?

Yes. Especially the ones that are all plastic. Brought to you by the lowest bidder...at the insistence of you the taxpayer. Im assuming you are talking about these POS things...

Im thinking of the common round can style with the two prongs at 90 degrees from one another. They usually just plug into a plastic fuse block that offers no grounding. Its just a thermal switch in the power line. I surmise that the mil unit needs a ground for its solid state circuitry to...

Great info guys. All the lighting on the LMTV is 12v I had been searching by the part number off the old unit. That unit from erics may do the trick. Interestingly he shows the pinout info. Pin A= Flasher output Pin B= power input Pin C= ground Before I buy it, Im going to try to connect...

I believe it is the same as my A0

Does anyone have a source for a replacement flasher unit ? Part number 12418344 Out of an M1088A1 The few that popped up searching that number are out of stock

Retiredwarhorses is the best resource. That notwithstanding...some of my comments will be to make sure we all know exactly what you are describing. One mans bad vibration might be another mans misfire. So it sounds like the engine is running smooth on all cylinders from your verification. So...

The "holding a conversation" thing cracks me up. Then seeing dynamat on the cargo floor. That's not where most of the noise is coming from. Id invest in an intercom system. Im doing a VIC1 system for the military look, but a better option for you would be an aviation style setup that is cheaper...

Is it misfiring? Is it chugging or have a pulsing feel when you hold your hand near the exhaust pipe outlet? More than likely a clogged injector or two but strange things like tobash mentions do happen. Mine had a broken alternator bolt that allowed the alternator to vibrate so bad that it was...