Search results

Matthew, This is Rick's truck, he has a handrail on his but I have seen many without. IMG_3190 The ones that I saw were not mounted to the truck for transport, they just layed in the bed. Bert

Jim, It looks like you made some great progress on the rear axle and pulling the engine. :beer: Bert

Doc, It looks like the squirrels ate the whole center of your steering wheel. :shock: Bert

Ken here you go. FRONT/REAR PROPELLER SHAFTS – NAPA# PUJ305, Precision# 305, Neapco# 2-1400, AutoZone# 2-1400DL (2” Inside Lockup x 1.231” Brg. Cup) [WC, WDX, PW and M37 Bert

Looks like the truck is in pretty good shape to begin with. Good luck with the rebuild. Bert

Looks like very good turnouts at all of the parades.[thumbzup]

Have you made any more progress on this project? Bert

Paul, With this bill being passed, could I use my Hobbist plate again? Bert Thanks for all your help guys.

I agree with the post above, restore the first one to original. Bert

MEK = Methyl Ethyl Ketone You thought your eyes got blurry from a little sanding and primering wait to you open up a jug of this stuff. Please use caution because the flash point is only 25* F. Take great care not to mix this with acids, you will not enjoy the end results. Bert

If you haven't logged on for a while, there had been some rule modifications and everyone was prompted to re-read the rules. Bert

I think your paint job came out very nice. How many rattle cans for the whole job? Bert

Jim, It looks like you are making some good progress on the truck. Is there a reason why you went with the bronze bushing rather than the roller beraings in the top pivot on the axle? Bert

Irv, A standard bolt is either 5/16" 18 TPI or 24 TPI. The antenna that I have is fine and worked great until the little pin broke off in the receiver. mistaken1, I have to agree that the HT or KR on the Comtelco site show some promise if I can find a chassis side / female end to make...

The last set of pictures are great. Bert

I don't think it's a SMA connector but I could be wrong. I measure .306" major thread dia and it looks like 32 TPI with the thread gauge. I have several PNs off the antenna pkg. FSCM 63747 MFR P/N 8582283J01 DLA900-88-M-AE02 Manufactured 8/88 5985-00-378-0156 Bert

Did you take Lulu out for a spin? Bert

Here is a picture of the area on the receiver that the pin broke off from. I also highlighted the area on the rubber antenna that this pin goes into. Both are the left side of the picture, sorry I couldn't make the lines wider. Bert

Factory tuned is fine but depending on your application it may let you down. I would recommend a power source that is directly off the battery otherwise you may pick up whine off a heater blower motor or accessories. Bert

I was doing a monthly inspection on my PEWS system and broke the male end off the antenna socket in the main unit. I still have the hard wire version functioning but will need the wireless version up and running. I will need to repair this but I'm not sure were to find replacement parts. The...