Search results

Dean...The one I have will mount to existing holes if mounted in the center....or put it in the back area and you will need to drill holes, 2 ea. I think. Mine is not mounted, just fit checked a year ago.

I got a 218 in there with an A2 tank with shields. Greg

The transfer case should have a round metal tag with red markings, and a screw thru the center, on the aft facing side, also the 218 has a fixed rear yoke, unlike the newer NP-242 for later Humvee's which has a slip in yoke. Greg

I don't have one yet...I was asking if tcody still has it.

Still got that reg. ?

That tach is the A1 Humvee tach that mounts in a box that mounts on the eng. dog house.... I have the same thing. Later they changed location to windshield area. The Oshkosh truck had it to, with the lighting, Humvee had a plug over hole where light goes. Looks like the M35A3 photo tach only...

I have some A2 Humvee Eng. wiring harnesses available. # 12446828 They are used, but nice.

I think the CUCV 400 is the same, except it has park . Park parts is what alot of us are adding to these mid 80's humvee's trans The shifter would need changing to a later shifter with park.

And M101A3 and other M101 series.

Ya....Me to.

hmmwv I have a project ready to sell here in So. Calif. An M998. Greg

Mount I have A nice New style pintle mount and pintle riser available. Greg

That 5/8" glass is for your M1025 if you have the proper bezels. I have a bad piece of A2 glass and that thing is heavy, and 1 3/4" thick. That Epay seller has HIGH prices. Those glass I've seen go for $ 150 on up when you can find them.

I sold the one on Epay.....I also have another one. Its 3/8 th thick hardened steel. I'm planning on finding an aluminum plate I can make to look like the steel one, then sell the steel one. I'm about 80 miles from you. Greg

For Sale M101-A1 trailer 3/4 ton. $ 875 Located in So. Cal.

Pintle mount with pintle Here's a new one with pintle perm. installed. { old style } PM me if interested Greg

I have a civilian 94 Hummer book...they are the same. I also looked up the Military ones.....there the same. Greg

I used a Ceramic 300 ohm I got off Ebay, ..has to be the rectangle type block looking one to handle the power. I had to buy 10ea. I have extras..........Need Some ? I can go buy some padded envelops to send some out... send me a few bucks to my Paypal . Greg

I had a meter that was also bad. It was the ceramic resistor on back at the hot wire. Some have the resistor mounted externally. I tested the meter without the resistor and it is a 12vdc meter. The resistor cuts the 24vdc down to 12vdc before entering meter. I attached a new Ceramic 300 ohm...

I got a 4x4 Sub with a 350 motor...400 trans, 241 transfer case....came with a 14 bolt semi-floater.....took it out, and put in a 14 bolt Full-floater with a locker 8+ years ago. Wish it was a 6.2 diesel....mileage is pretty bad with a gas motor. Greg