Search results

Here's what the valve looks like removed from the housing : It may be the O-ring.

Shim is # 1 Make sure you have bracket # 9 also.

They are the ones that need a AS3900 base.

I'll be in Texas in a week and plan to get some more A1 bumpers and brackets. Never herd of an A2 aluminum bumper....there were ao/a1 way back....steel is the only way to go.

I have a bad Hmmwv column you can have, just pay shipping.

going to Texas from So. cal. and back with a 20' trailer mid Jan....might have room for stuff.

Are you going to make it a slant back still ? That windshield is a soft top one.

Wanna get rid of that bracket assy. on the left sponson ?

Outside black parts...epoxy prime, and then Carc. Or flat black powder coating.

There is an early and late style bracket....late one has slotted holes to raise it for trailer hook up.

The newer black one has a totally different latching part for the section that you pull out. I had some small towbar feet machined down to fit the Hmmwv towbar.

MT's are pretty cheap now days, and are alot better . Even better than that...MT'Rs are best choice. ** easier to balance }.

PM sent

Bft Here are some BFT brackets and antennas I have found.

Place a wanted add for one I have a new 4879 avail.

Nice truck...lots of parts out there. This site and G503 are good parts and information sites.....lots of Hmmwv guys on them.

Its only on a data plate on B pillar L/H side

Two different 242's can be used. Early has a 3 bolt tail shaft, late has a 4 bolt tail shaft. Early has a small slip yoke, late has a larger slip yoke rear drive shaft.

. Tighten locknuts to 85 lb-ft (115 N.m}in tightening sequence shown , then Tighten locknuts to 110 lb-ft (149 N.m}in tightening sequence shown . Check for gaps at each stud with an 0.0015 gage. ..I tried to add a photo, then tried to delete these small photos....I won't let me. Googe search to...

American Milspec is selling a real Cied antenna for $ 585, {FRF-105c}