Search results

Sorry I read that, then forgot it.

I use the John Deere 50/50 pre-mixed. I use it in all my MV trucks.

:ditto: Also is the fan coming on?

Thanks for the info. :beer:

I think about him each time I get into the MV trucks. RIP

That does sucks!! Sorry!

I am trying to replace the front axle seal on my M936 and I pulled the old housing out (that was a job!!!) and now I am trying to install the new one. My question is on the back of the seal housing their is a key looking thing, is it important how the key faces? To the front, back, top or...

I think the heater is the only thing that uses 12v. There should be a wire drawing under the seat in the battery box under side. I would just hook them up to make 24v then tap off the 12v. Good luck!!

Jet A will clean your fuel system!! May have to change your filters. Also I think it is very dry, you may need to add a little oil for the IP pump.

Man you did have a Long day, but you made it home safe that is the main thing!!! Glad I could help a little.:beer: :driver:

When I run the winch HD oil pours out of the holes in the drum and the vent on top of the gear box.

I picked up an oxygen bottle from a salvage yard for $25. It looks the right size, just needs a little paint. Just going to use it do demo.

My hoist motor is leaking into the winch gear boxes. Have not had time to work on it. Been working on the front axle, bearings in the right side all rusted up. Anyway here is a my SS link to my thread. https://www.steelsoldiers.com/threads/hd-motor-on-hoist-leaking-m936.93634/ The data...

PM sent Goog luck with trip.

My lift side windshield wiper was leaking a little and I could hear it off and on. I had to get my wife in the truck to find it.

Pics of the Vise installed.

I was in a surplus yard looking around and there it was, It would not open. So I tried to get it apart and pulled and pulled and finally got it apart. It was not rusty at all inside, not sure why it would not come apart. Took a wire wheel and cleaned it up and painted it 383 green. Looks like...

I got my whiffletree pins finished today that I made. Tried to make them as close to the stock pins as I could. Forgot I got my Vise installed today also.

Rickety Bones, Looks like you got a nice setup there. I ordered the filters for my Gen. this week, hope the IP is ok. Thanks for all the info. in the tread.

Were did you get that air powered pump? I like that.:grd: