Search results

Great pics, thanks for showing the trucks at work!!:beer:

I would go with a 5 ton. I towed a Deuce with my Deuce one time up some long hills and it will get down to a crawl....... On one hill I got down to 20 mph and that was only 12,000lbs.:oops: Sure it was 110 degrees.

[thumbzup]

If your priming pump is good it should not take too long to go from filter to the IP pump. Maybe 30 pumps. Did you open the bleeder valve under the pump? It can be a PITA. When I replace the filter I put a little air pressure in the fuel tank to push it up to the filter faster. If you have the...

I do this when I park my truck for a event. I also like the idea of pulling the Emergency Stop handle and the padlock in the steeling u-joint. 1. Locking Door Handles 2. Keyed Battery Disconnect Switch 3. Steering Wheel Chain and Lock But if they want it and have the time they will get it.

Nice!!!:drool: I would love to have a tank!

I am headed to Austin, TX in Nov. with an empty 16' trailer and I can bring two cabs to TX if anyone needs help with trans. I also can pick them up in Barstow and store them till then or store them till you come pick them up here in AZ.

Thanks for the filter part numbers!!! It looks like in the TM that the M936, M936A1 use the same filter.

ARYankee, Nice find on the M936. But in my set of TM's it is on page 3-108- 3-111. same tm number done in June 1998 Thanks!!![thumbzup]

Now one more filter to change. Thanks for posting.[thumbzup]

Very nice!!:driver:

The Brakes looks the same, but the pads look different. If you pull the seal retainer (housing) it is just a plan to get back it. I do not think it would leak around it. I did not use any sealant. I did not replace the boot they looked new. Just were lose and it was a zipper one. Good luck...

Thanks and I am glad also we made it home.

More pics.

When we picked up the M936 at Barstow the front axle on the right side started leaking on the way home (320 miles). I got around to working on it and here is the story. Pulled the hub off and noticed the bearings had rust all over them and were about to come apart, I am sure of that.:doh: Then...

I think that is what I will have to do. Thanks!

Looks like you are doing a nice great!!! Keep it up!! :beer:

Anyone?

I do one Knuckle below the fill hole.

I am looking for some new Radiator Hoses for my MEP-005A. Has anyone found some anyplace? I searched around and have not found any numbers here on SS. Thanks!!