Search results

Please attach a picture of the Gen set Data Plate. Please attach better pictures of the I.P. Please go to the TM section, and down load the TM's for this gen set. It sure looks to me like you might not have the right injector pump, and the Electric actuator is definitely not mounted on the...

I am soooooooo happy I live someplace normal!

The man asked how to check it. No one answered. And maybe he can find someone in town who has one. Oh Yee of Little Faith!

So how much load were you normally pulling when the set ran fine? Sounds like your flywheel bolts came out, or sheared.

There are several different models. I saw a trailer like this in a M.I. Battalion. They had 4 of them. The reason I like it was because of the big "I" beam looking mounting stands for the gen set. If you sit a 802A or 803A into the trailer, you have no room to open the engine doors all the...

Open up TM 5-6115-584-34. Turn to page 8-4, (Or PDF reader page #153) h. Testing Generator Stator. (1) High Potential Test. Test generator stator as given in paragraph 8-2e of this manual. Replace stator having faulty insulation. (2) Winding Resistance Test. Perform winding resistance test...

Exciter voltage. Main gen will not light off.

Lookin good!!

And with a 4K and TPU!! Extra points for Fuzzy!!

Start with disconnecting the: 1. Battery charging alternator. 2. Both electric fuel pumps. The set should run for 15 min, on just the day tank. 3. The IP, like Ray wrote above. 4. The fault indicator. It should pop its own fuse, if something is bad. Unless its over fused, or has tin foil wrapped...

The bad part: I don't know. Sure you do. Loose plugs. Why do you think I wrote what I wrote in message #46. Its a KNOWN problem with ALL MEP-8XX-B models.

Also check that the two canon plugs on the backplane are tight. In fact, check all plugs in the control panel. They are a known problem area.

TM for the Breakbulk Trailer M-871R, M-871A1r and M-871AR2, 22 1/2 Ton TM 9-2330-335-13&P Note: This is the latest edition published Dec 2015, which supersedes TM 9-2330-335-14&P dated 30 September 2008, including all changes.

Please submit this on the TM upload forum. I will try and find a place for it. Great info.

Never will see my rig clean as any rig here, water is too scarce to waste and it works for it's keep which means soon as it leaves the driveway it's going down a dirt road working. I use this excuse for my motorcycle too! :ROFLMAO:

Yes as soon as i start the unit it goes to full load and puts a heavy load on the engine . No voltage on the meters and i did flip the ac interrupter. Lets try this again. You started the gen set. It runs normal. You flipped up the S5, and it goes to full load, and bogs the engine down...

Are your batteries fully charged? Often, when the Cursor will not move, the Batteries are low.

Thinking about something like this: https://kraftsmantrailers.com/sites/default/files/model_f1-16_1.pdf Their 18'+4 version would work fine and it's 2000lbs lighter than the M1061. Be hard to find here in Germany. But there are lots of trailers for sale here, more or less like it. And they...

Like the movie "The Flim Flam Man" With George C. Scott.

Off hand, I can not think of a HMMWV trailer that can be big enough to carry a Moog.