Search results

No. And you always test a diode by removing at least one end of it from the circuit.

I assumed it too. We have to get an answer here, to go farther.

He said he had voltage before, or not?

Ian, This thread is several years old. Might not be anyone going to answer.

You have two threads started that more or less are the same problem, same gen set. Please decide what one you want to keep. and tell me. Because I will delete the other. KLOPPK is also someone who can help with a new or repaired VR. Kurt, have you read the other thread?

Above your red circle, is a test/Reset switch. When you have a fault, you have to reset the Fault indicator before trying to start again.

Have you reset the fault indicator?

Good morning I am new to forums as far as actually posting anything so up for chastisement for any wrong doing, and new to the newly purchased 805A generator. I bought it not running due to sitting for a couple of years and had various easy fixes such as draining all fluids and changing them...

There is only one start position on the S1 switch. When it starts, and you let go, it springs back, (or is superposed to) in the PRIME & RUN Position. You can then turn it to the PRIME & Run Aux position, if running on a aux fuel source. So, you are trying to start the set, in positions that...

It would appear, that all TM's for the P19 are not released to the publish, so we can not post them here.

It would help if you gave us a bit more info on the truck. What is an arff? How about a NSN?

Has the Quad Fuse MWO been done on your set? Below is the MWO. Its not going to fix your problem, BUT, BUT, it will protect your Quad winding's if your VR goes bad in the over volt way. This could be an R1, Volt adjust problem?? Peter might fix your VR's. Lets see what he has to say. @peapvp

Then this is a clear sign you need to take the K1 out, disassemble it, clean it up, reassemble it and see if it will work right. Perhaps you need to delve in to the -24 TM and read how the system works. You are worried about DS7, when in fact you have no output. DS7 is telling you that. Fix K1...

Do you have the TM's down loaded for the gen set? They are here, https://www.steelsoldiers.com/threads/all-the-tms-you-need-to-work-on-the-mep-016b.154722/ Look in the -24P to see what part number starter you need.

If you have no power to S1-3 in the start position, then your gen set will never run. Get a new switch. And I have to ask, is S10 in the run position?

No military gen set will start with the S7 turned on.

One of the sets is an MEP-804A, and the other is a MEP-804B. Where is "480 showing". The meter? The output terminals? The DS7 only can come on, when the S5 is placed in the Up/On position, AND the K1 CLOSES. So, when you actuate the S5, and don't get a DS7 light to come on, is there output...

Looks and sounds good to me!

Is this picture showing the part you are really looking for?

Boykindennis, Please change your location to the state you live in, IAW forum rules.