Search results

Often, it helps to simply disconnect ALL the cables on the batteries. Then hook them back up IAW the schematic. If someone else before you, or you, have hooked up something wrong, thats the only way you are going to find it.

Can you read schematics? If so, You need to check out if the S9 is sending initial excitation to the Main gen. Should be S9-2 function. Pins A&C I think.

CB is a Circuit Breaker. I would tell you what it is and where, but I am not a truck guy. Someone will jump in here I am sure.

Have you pushed the S9, (Over Speed Switch) reset button?

When you hold up the S2, (Start Switch) and let the engine go through its starting phase, do the volts and hertz meters move at all? Do them come up, until you let the S2 go? Or make any movement at all? What voltage do you get at the 120 volt outlets? Do you get any idiot lights, after letting...

DA Pam 738-750 explains how to fill out the forms.

Power One, je ne comprends pas

Did you hold the start switch up long enough to let the set self excite?

Tight vote here!

Chucky, I bet there are lots of snakes out there. You be careful now, ya hear?

I highly daubt the Optima battery is "dead". I know they aint what they used to be, but just because someone tells you its dead? No. You need to check it out for yourself. Get a battery charger that is made to charge that type battery. Then load test it. Its very hard to really kill an optima.

I also have such a folder for one of my MEP802A generators. It contains these forms: DA5823 Equipment identification card DA2404 Equipment Inspection and Maintenance Work sheet AWRDS BII/SKO Inventory Report DD FORM 314 Preventive Maintenance Schedule and Record DD FORM 314 Preventive...

Why don't you open a "Parts Wanted" thread?

I know, old thread but mine is having the same issues. Was the fuse LITD mentioned the added fuse on the back wall, (No) or is there one right behind the guage panel I missed? (Yes. its labeled FU1) Perhaps you need to read the operators manual? Have you down loaded the TM's, They are here...

La2Butler, Please write you state in the location block, IAW the Forum rules.

This is DA Form 5823. This is the form that fits in the pocket on the Log Book cover. Back in the day, there was no DA Form 5823. It was simply a 3X5 card, filled out with the same info, shoved into the pocket.

That was my intention.

Start with the easy stuff. Pull, clean, test, reinstall and readjust the MPU.

Might be a good idea. Lets see what other forms I forgot. Then put them all in one place.

Dont guess. Its on a data plate on the side of the gen set. Have you downloaded the TM's and started to read them a bit?