Search results

Sorry off the grid for a while, no I just asked a truck junkyard to find one about this leanth and this diameter and spline.

Just did a “tas 65 steering box” search, lots turned up. Very common. from $175 to $1400

Sorry, can’t remember. Just used a cat bolt on pump.( piggybacks the air compressor) borgstroms? For steering u joints etc. reservoir from Amazon. And had two hoses fabbed up.

We have 53” and had to get a new pitman arm out of a truck junkyard to make it work.

they DEFINITELY won’t fit

come on, if I see one more bi turbo V12 merc put in a hmmve I’m gonna puke. would someone just once try to think outside the box?

Sealer, stupid spell check!!!

If your “o rings” look good just use some seale. Only had to change 1 ”o ring”, a friend did not line it up on his assembly and would not hold air after an hour.

Yep, fuel

And maybe one or more of the rear axles are moving around which is affecting your steering? And swapped in dextron 3 in our trans about 4 years ago, much better now.

Looked today and got some measurements, from the steering box,have a 6” steering “arm” connecting to the shaft of the box, leading down to a steering arm connecting to the steering “axle knuckle” with a center to center of 9”. the 2 to third axle wheel base is 60”. The springs are three leaves...

Sorry not exactly a tech savvy guy. Will also measure the Pittman arm and to be honest I thick we did some calculations and by dumb luck it came out right on figuring the Pittman arm ratio.

Can’t remember where we got the springs. But we put the 53” tires on there for speed and durability. Will go out tomorrow and measure the 2nd and third axle wheelbase. I‘m guessing that a spring manufacture place can set you up. and I will measure the width and thickness of the springs also...

Yea ours is the same way, makes me nervous when any engine I’m behind isn’t showing 30 psi or better at idle. But some are just fine for many miles like that.

Marv Marvel mystery oil is basically two parts low flash point solvent and one part atf. Just look up the MSDS and there it is. I have never been a fan of putting solvent in my engines.

Or a trailer?

W We bought an A3 5-6 years ago, yes it’s nice to put ‘12 2X4s in the back and we can put 3 four wheelres in the back when we go ride. we modified it with a aluminum top, stretched the rear axles to put the “53 tires on it. which of course raised the cruise speed. It’s been to Indiana and...

Sorry, just got back home from being on the road for a while. “.032 is easy to bend, held in place with “Clecos”, straitened it up with cargo straps. had to use cherry rivets for the blind holes at the bottom. used “3/16 in the blind holes, and used “5/32 solids for almost everything else. and...

Used “.032 2024 T3 for the round sides, .040 for the center back and .062 for the top. In case someone stood on it. And we have went through many tree limbs with no damage so far.

Ok found some pictures