Search results

Drill, tap for 1/2” bolt, large thick washer ( or large piece of 1/4” steel) And wala, will never come out

Tulsa veteran day parade

Or just remove the safety chain plate (that will gain you a 1/4”) then cut it in basically thirds and use the two outboard sections (chain loops) and outboard bolts to secure the cut down safety chain loops.

24 volt one wire alternator, Amazon for example-$90-180

My apologies for making it clear as mud? Your safety wire would be great if they where left hand thread bolts

Wire should keep torque on fasteners. in other word, wire should keep bolts pulling tighter. Your picture shows a few pulling “looser”

Idle with the trans in drive and try going through the gears. Did the filters in ours and filled a little over and had no problems and and after a short drive fluid level was good.

One thing to consider is where that heat goes after exiting? Like is your rear axle going to be in that heat stream? and I would not be concerned about noise because the vanes on the turbo normally??? do a good job of mitigating and absorbing the exhaust pulse noise.

Yea the granddaughter likes blue

Guys we’re sorry but just trying to “upload? “ Some pictures of the metal top we made

One word sailrite

And???? If you want to learn to sew, look up “Sail right” sewing machines, bought one a few years ago and I have never used a sewing machine before. We have used it for seat covers, convertible tops, tool, gun cases etc. can’t believe the stuff it will sew.

We had a M35A3, canvas top. Of course it was old. Looked, measured and made a great top out of aluminum. Turned out better than we ever expected. Made it a little taller, made a little center console, with a dome and map lights. If I knew how to post pictures ( old and seriously computer...

Well I assume you have communicated with and attorney and I am not an attorney in an way. But….if the storage yard auctioned if for more than your bill, you are supposed to receive any overage. Yes to big of a trailer and hopefully it was loaded correctly ( weight distribution) and also I...