Search results

I sent you a PM I'll take some pictures tomorrow

I got one similar to that but it's taller.

When you going to get back to the priest with the radial in it. Might have to come down and see that thing light off. If nothing else I learn a few new cuss words every time I'm around you. Just kidding you have a lot of patience . "working blind basically while looking at a reflection in a...

probably because of you!!

Grab a cold one and read through this. https://gear-report.com/help-hmmwv-wont-start-humvee-glow-plug-start-system-maintenance The batteries could have been toast but the guy you bought it from used the nato plug and jump started it. that's why it was running when he arrived to pick it up...

I never was in the service . But I soon learned what HMMWV stood for . And once mine retired from the Marine Corp the Acronym changed from High Mobility Multipurpose Wheeled Vehicle to High Maintenance Money Wasting Vehicle. Nobody in there right mind should own one if they can't learn to...

You said the battery was dead as in " one " and you replaced "it" with a yellow top. Also you are turning a " knob" what " knob" are you turning. More then likely your glow plugs need to be replaced as well as the control box and the TSU. Also you need to make sure that both of your...

I'm trying to figure a way to load and unload a custom doodad I'm making for the bed of mine but it doesn't extend wider then the inside width of the bed. thinking of building a trailer mount for the doodad that will lift it level to the bed and slide it in . like a drawer slide.

check the spacing and measurements first. I could be blowing smoke. Might look into a set of those camper jacks so you can lift it up off ground then back under it. Just an idea. Have fun with it . it's a cool set up.

Holes probably line up with the existing 3 at back of truck bed and 2 about even with the where the 4 man bulkhead would go. I think the front one is where the tie downs are

Every military truck is issued a pick / Maddox, ax, shovel, sledge. not so much with a hole saw and cordless drill

the holes in the floor were put there as a field mod in almost every truck . To let water out of the thing. since you can never make them water tight. Most of the holes I've seen look like the were made with the end of a pick then opened up with the other end.

I think its under HR PUFF and Stuff.

I guess I missed the Big title of 4L80e shifter. But most likely for back-up lights

Perhaps if you told us what year and what engine / transmission was in the vehicle originally it might help. Also if you gave us the #'s you can identify it would help by elimination . What shifter are you removing ? a 4 speed? there will be a neutral safety switch, possibly even a switch for...

try looking it up in the TM. top of the front page

Almost every question you can ever have will be found in the technical manual . This site has a pretty good TM library found at the top of the home page. This might help you find most of the basic stuff's location https://www.steelsoldiers.com/attachments/a1-intro-to-veh-sys-booklet-pdf.698779/...

He was pretty specific in the title to his post. he said in a 78" or any IBIS TEK LIGHT BAR

it's Gloss Blue !!!! That right there is a problem that would require immediate attention .

the cooling fan comes on around 220 ish drops it back down to around 210ish the first time you hear it you have a WTF is that moment. and yes you will feel a lag when it's on