Search results

I agree with Milcommoguy. I have heard both sides on the supplemental grounding harness installation or not. All I can say is I have cleaned every ground I found. I have had no issues. One thing I did find was if you do not coat the connections with dielectric grease, you will be amazed with how...

I'm in! Thanks!

The insulation is critical in having a nice driving experience in my honest. It helps with heat and noise.

Did your cleaning include the ground stud that is to the right of the Panel directly in front of the Dog house? it spans the inside and outside of the Truck's body.

The Serial Number is on the inside of the Tub at the back of the Drivers door. When I had both my Humvee's Titled, that's where the employee went to verify. I have never seen anything on the Frame.

Trivial, but I could not resist. Made out of aluminum and pretty good quality. Besides, what can you add to your Truck for less than $10 shipped? LOL

Should have waited to sell my M998. Day Late, Dollar Short, buy high, sell low. LOL

The 6.5 + OD Trans made a huge difference in drivability my opinion. Now I do have more weight as well with my M1045A2 versus my M988.

But it the end it did have the engine replaced. I'm talking about the Plate on the Block. As far as the Trans, my Mechanic changed the fluid and stated whoever worked on it sealed the pan with Silicone, which is a no no. That was fixed. I never really researched the MVO's. I just liked the cool...

If your Glow Plugs were shot you would have to crank the motor until she fired, then you would have a bunch of smoke that would dissipate as well.

There is a cold start advance that advance the timing during startup. This what you are hearing. I drove that truck until they salted the road's over the last couple of years. Its located just inside the Dog house on the passenger side of the Block. This is normal and you should have no...

I run them on my rig and love them as well. They are bright Action. At first, everyone flashed me, but after adjusting them no more flashings and I love them. You wont go wrong with these and I got used to their unique look. Actually I like it now!! They are a quality unit. I would take the...

It's an H1 Action! That would still be a HMMWV, not a Hummer. I also saw a sticker calling out the Jeep community. I don't have a picture, but it said "HMMWV, like a Jeep, but for Men" LOL When I sold my M988 I had that slogan at the bottom of my sales sheet. I pointed it out to a young Guy...

Welcome to the group. Check out my new bumper sticker. My wife gave me a hard time, but I couldn't resist!

If the light just stayed on for a second and went out I would say your Glow Plugs are Toast. Depending on what the light did before that, the Smart start / glow plug controller could have let the smoke out as well. I have the same Truck and all three were smoked when I took possession of it...

Without the insulation the Tunnel does get quite warm. I put my two dogs on top of it in there beds for a ride to Ma's house and could not understand why they were panting! LOL. Since my Truck has park, I never touched the handbrake to know if that gets hot as well.

I must say, that is a clean installation and the look I'm shooting for. Thanks!

Eastern Surplus has them with the Winch installed. I asked them to separate one for me, as I already have my electric Mile Marker Winch. Its been a week and have not heard back. Thanks for the reminder, I'm calling them now.

Thanks 86. So I guess it goes back too picture #3 for me. That's where I started and Coug installed. I need that Plate all. Who has one for sale? Thanks!

I'm in!!!!