Search results

Seems the Airtex E8131s arent available anymore online.. and I think the 8135 was a cross as well, which I am also having trouble finding past obvious Chicom generics. If your primary pump is DOA, and you need to get a working solution NOW... you can take the rear fuel tank cover off the...

Does she have open breaker positions in her box? You could go even lower tech (but just as safe) and move the top RH (2) breakers and put a simple interlock kit in place. They make specific models, for specific breaker panels. They are low tech, and work perfectly every time (and are very easy...

I have a 200A service too, and I am able to run everything except my dryer without fault. Multiple fridges, multiple freezers, gas range, gas FHW, lights, tv, internet, well.

Honestly she should be able to keep them all on, if those appliances are gas and have no high draw coils in them. Well pump? Whats the range, oven, and clothes dryer powered by?

I think we understand now. Do know though the more technically correct you can be with terminology, the more common the understanding will be between those helping, and those in the future searching through threads seeing if anyone else has had the same issue as them.

If it were me, I would use a spider box. It will allow you to get more amperage out of your genset instead of being stuck at only 30A, is waterproof, has breakers, and is designed to do exactly what you want...

Yes you want to rotate the rack pin on each pump all the way to the left and then rotate the fuel inlet barb as far right as you can go with the hose in place. The pin of course is what does the removal of fuel, and the positon of the fuel inlet barb allows the range of fuelling to be...

How's it holding up? :)

Being that you broke out the BFH on those poor little metering pumps, you might just need to work backwards. Disconnect the hard lines above the pumps, and push aside... and try to start. Are they all pumping fuel? If so, reconnect the hard lines, and disconnect at the injectors and crank. Is...

I will just leave the topic alone here forth.

Let the fuel pumps run and prime the main system for a good minute. Crack the lines at the injectors until you see both spraying fuel. Clean it up, retighten, and go again. It might take two more times, but it will go. Just make sure your batteries are in tip top shape. They will recharge as...

Your listing does not say new, it says " REMANUFACTURED to OEM specifications". That language isn't interchangeable.

https://greenmountaingenerators.com/product/ambac-m50-fuel-injection-pump-50-24a-80a-9540a/ I would think with that kind of margin you could just retool these in the far east new?

I would recommend starting at the genhead side cylinder, and move back to the radiator when installing.

It still sounds like an alignment issue... it doesn't take much to make the rail want to not move. Remove them all, and install one properly and see if the rail moves... go down the line until you have an issue.

Yeah either the Dodges or the older Dana 60 F350s have the same pattern too from memory.

All I see missing from the list is adequate over the road snacks and music. I think you have the rest covered.

It used to be nice pulling out of Chambersburg, there was a tire shop right across the road one could air up at :). If you have the lockout bolt, no need for brake fluid. I just pulled a trailer from Maine to MA over the weekend (with an LPW2 on it) with the brake locked out from the getgo...

The chains on the trailer will be too short to go to your vehicle, you will want to bring along a few quick links or some cheater chains to make up the length. They are fine for a HMMWV, but not a civilian vehicle. Also if the trailer is aluminum, you will need to figure out how to keep magnetic...