Search results

If you install a flex plate backwards you can have problems like is being discussed here. The center hole always has a manufacturing burr that can NOT be installed towards the crank. The smooth side must go towards the crank to mate correctly. I have never had to enlarge any hole for a GM flex...

55 mph is going to be rough enough without any weight on back anyways! It is sometimes too fast if you have to get on your brakes hard when bobtailing. Have fun and be safe!!

There are two fusible links connected to the 12 volt diamond in the center of the firewall. One of these goes to the ignition switch. Pull on both of these fusible links pretty good. The fusible link can look ok but will stretch or pull apart if burnt. If one pulls into replace with proper size...

Me too. Maybe next time.

What color is this "dark fuel oil"?

She sounds like a keeper to me!! Was your power out in the January ice storm any? I hope they get your power back on soon!!

Wasps are really bad to get into any protected area on farm machinery too. I prefer to spray them with a full can of WD40 or any other spray lube instead of chemicals. Spray directly on a nest and they can not fly and will drop to the ground where you can mash them. I believe CARC paint attracts...

Hello, Is anyone available to do a preview at Beaufort, SC before mid May? If so PM me for the details. Thanks in advance.

Welcome from western OK. Good luck on finding your first one!!

Yeah, 10 bolt cover, 4" axle tubes, distance between spring perches and dually brake drums, Dana 70 HD. Can't tell what ratio from here or spring perch center to center. It would be good to have u-bolt caps and sway bar to match with new u-bolts.

rustystud, Thanks for this list of reasons for "fluid burp". Good luck and wishing for a speedy recovery from your kidney stones!

Stay with ACDELCO on starters and alternators both whether remanufactured or new. You will be glad you did!

Ok, good job. I can see them now in the daylight!

How did you get by pulling it that far without lights hooked up?

I have one of these on the house and it works great and is simple. Located just below the meter in breaker box.Turn the main breaker off, slide the interlock up, and then you can turn the 100 amp breaker on that the generator wires to. My power company installs these on new hookups for an extra...

Try looking at the TM9-2320-289-34P found on this site. The 34P has the part numbers.

Welcome from Reydon, OK. What did you make the good looking welds with?

That's the one you want. Voltage regulator will have LED lights on it for 12 and 24 volt. My M915A1 came with one of these and AC with the rebuild. Artisan had a good write up about these in his M916 build.

Rusty, What was the operating speed of these transit busses?

A tap with a little thin grease or oil on it to catch and remove the carbon cuttings! Be very careful and not thread tap in too far!!