Search results

Well, Private Snuffy put in some Home Depot fittings. Any thought on where to get the proper elbow? Most I have found are not metal sweep elbows like what I have seen on other trucks.

Well, the Waterloo harness is not long enough for anything but the stock location. May have to look at maybe higher. Sent from my iPhone using Tapatalk

I ordered some FlexFab 5526 on Amazon FlexFab - 1" ID x 10 ft 5526 Blue Silicone Heater Hose 25mm 350F Radiator Coolant https://a.co/d/77is4Sa Only 250psi, but way cheaper. And, if I get anything near that, I have bigger problems. Sent from my iPhone using Tapatalk

Thanks! I have a winch, so the factory location may be annoying when restringing the cable. That is my only concern there. But maybe it will work just the same. Sent from my iPhone using Tapatalk

Thanks…. Added 2’ to each length just in case. Sent from my iPhone using Tapatalk

Do dryer filters always need to stay upright? I have never seen them not mounted vertically. I am contemplating putting it on my cab right side step box. But, that would flip over when cab is flipped. Also, does the trinary switch mount in the top of the dryer? Sent from my iPhone...

For reference.

My coolant line from the tank to engine is too short to fit my AC compressor into place. It would rub on the serpentine belt if I moved it. The TM calls it: Rubber silicone class Q 1” 400lb rated. I found 50psi rated silicone hose. Any thoughts? Also, probably should swap the Home Depot...

About to tighten condenser in.

@GeneralDisorder Did you have to have the hoses on the condenser before installing it, or is after ok? Sent from my iPhone using Tapatalk

For lower bracket mounts, did you reuse the engine mount bolts or buy longer ones? Sent from my iPhone using Tapatalk

Should I paint my pulley? At least the non contact surfaces? I was surprised that it was just bare steel. Sent from my iPhone using Tapatalk

Just use “cat service tool catalog pdf”. Found it. Sent from my iPhone using Tapatalk

It would be nice if our heat index was closer to 100….. our actual temperature is over 100….. heat index closer to 108-115 here. Sent from my iPhone using Tapatalk

I am just wanting to keep water and dust out of my spares. But, that would do a better job of sealing if the threads are in the sealing washer. Sent from my iPhone using Tapatalk

Thanks! Do you think I can prime tonight, or should I wait longer? Sent from my iPhone using Tapatalk

Ok, I was pulling off my front skid plate and noticed the casting for the front right spring perch (M1083) had blistering paint. I chipped it all off as best I could (hard to get at), blew the dust off, then painted on ospho. Last time I used ospho, I saw instant fizzing. This time, nothing. It...

Ok, finally traced my hoses. The hoses are reversed. When I switch them back, we will know if that makes a difference with heat always on. Will update everyone. Sent from my iPhone using Tapatalk

Is it a standard bolt or a slick banjo bolt that is not drilled. Sent from my iPhone using Tapatalk

Thanks! I ordered my bolts! Sent from my iPhone using Tapatalk