Search results

After all that I went to a modified Rhino carrier and custom matching swing away fuel carrier. Still have the original tire carrier and fuel carrier collecting dust out back.

Oh and to answer your original question about only 2 bolts I made a 1/2 thick metal ring with 4 holes in it that goes over rim then the 2 lug nuts hold it then welded a post in the center of the hub with a hole in it for a lock then cut a piece of 1/2" bar stock to span the center hub. It was...

That is the original tire carrier made by AMG to the best of my knowledge. They also made a swing out fuel and water can carrier for the other side.

I'm well aware of that.

Get through the registration hurdle in Calif before you sink another dollar into it.

Let me know if that pump works to empty tank.

I'm glad I could help. 86humv is a good guy . He was my local go to guy till he moved to a free state. Put him on your short list when looking for any thing HMMWV. If he doesn't have it he can probably refer you to someone that does. I like to refer business to people I know that will do you...

I was under the impression we are not supposed to link to that place. But I'm not a moderator so I guess you know better

2-5/8" long piece of 1-1/2" x 2-1/2" 1/8" walled

If you can source clamp you can make the spacer piece. It's made out of a short piece of 1/8 walled tubing.

He may see this on his own and reach out I'll send him a pm to have him reach out to you. Yes basically same clamp. They made two front variations and 1 rear.

Not sure of part# Send 86humv a pm he can probably help you source what you need. They mounted to the B pillar support. They are spring clamps that clamp around barrel and are spaced off of the B pillar with a small rectangular piece of tubing.

I have a neat little syphon pump. Can we suck most of the stuff out from top?

Square head?

Danger ,Stranger, Thanks God you didn't offer him candy. Little creepy there Will. I know someone that can probably fit up inside that thing but he doesn't follow directions very well. At least yours!! Let's get this going after it stops raining and when you get back from the beach.

I believe all of those hoses are part of the fording system. Is there a fording valve below the dash and behind the E brake lever? If no valve is there a hole located there ?

M134 on a swing arm using a 1919 pintle. Not going to happen. It would be a bit more believable in the turret. Where's the ammo supply coming from. At 4-6,000 rounds a minute it needs a rather large ammo stowage device . Sometimes to much is over the top. I get it it's his truck . I'm not...

Did I miss any smoke signals? Awfully quiet on the 5 ton wrecker channel.

Welcome Your 1025 falls under the M998 TM's Top of the first page under TM section Look for TM-9-2320-280-10 TM-9-2320-280-3 Will get you started.