Search results

Antenna? That makes sense why it is missing. Demil requirements. I do have that huge power connector in the rear passenger floor. It takes away a lot of foot space. i guess for the hole, maybe I will stick a light in it or just plug it.

I guess that makes sense since it came with a 400a alternator. Any chance on knowing the partnumbers? Or photos so I can see what it looks like.

I was wondering what was mounted in this hole in the rear passenger wheel well. Does anyone else have this? If so, what did you use it for?

that weird… that was the first document I looked at and search found Nothing. It worked when I tried it again. Page 144. Thanks

Thanks. I’ve been looking all over and it seems the versions of what you posted that I have does not contain “Speedometer Harness Assembly Replacement” in it. Can you send a direct link and page number of where you saw it? That might help me out. Thanks again~

Hello all, i am trying to figure out how to mount some harness mounts for the 80mph speedo. All I have is this from the TM is there another TM that provides details? I assume part 10 goes inside the dash to offset the resistor so the wires can fit better. I al looking for exact locations for...

Congrats on getting that back. Still building mine and I know how much work goes into these things.

Thanks again action. I did see it somewhere that it was “AC request (not used)” somewhere. Also it explains why I don't see metal wire at the tip of the wire yet it forms like a metal wire when I bend it.

Definitely 348C i posted 2 photos of it because it is hard to see. No manual focus on cameras these days. If you look at them long enough, you can make out the 3 and more so the 4. The 8 and C are pretty clear.

Hello all, I have searched for what this wire is, but can’t find anything about it. Below are some photos: The list of military vehicle wire codes: The plate with 348 C code. View from the top behind the alternator. from the bottom far away: closer up close

quick question on this trans. The speedsensor wire on my harness has been cut to the nub. All I see is two white wires. If I solder a new plug on, does it matter which direction I install it or is one a voltage source and the other data? How to tell which is which?

Disregard, i’ve seen some photos online and the nipple is in. thanks again.

Hello, Quick question. for this piece, is the nipple facing in or out? the TM just looks like a circle. I know it is mounted on the outside with the plate on the inside. Just need to validate the nipple direction. I am thinking in. thanks guys.

This has been resolved special thanks to 86humv and excessinc (ebay) for getting me the parts I require at an affordable cost.

MS3450W16S-1S i believe this is the part number for the plugs. If wires are attached to them, even better. Makes it easier to solder.

They were already cut from what I know. they took the whole hood. I ended up getting a brand new hood from the same location for 360$ But it came stripped. I will either wire the lights directly to the cut cables or find the proper plugs and use the harnesses.

I will need those too, if I can managed to get the plugs that were cut off.

Hello all, It seems that the 2 connector plugs on my harness that plugs into the corner light harnesses has been cut off. Instead of replacing the harness, I was wondering if anyone had these off a broken ecv harness or had extras off an ecv hood they aquired. thanks.

Understood that all 27s are the same. Just said I had a few extras. And one of them is female. Trying to determine what the extra plugs are for. a diagram said m is fuel and n is tac or wiper, well something along those lines… anyways, i followed everyone’s advice and I did it! i used both y...

Going to look at this info when I get home today.