Search results

I would like to add a tach to my '53 M35. I have a tach drive for the gas engine (driven at 1/2 crank speed). Are the multifuel tachs designed for 1/2 engine speed? Does the tach use a 0.104" square drive like most speedometers? I am assuming that the whole dash and gauge panel needs to be...

Anyone have or know where I can get one of the curved head bolt wrenchs for the R6602 5-ton gas engine? It is like the one for the multifuels but for a 3/4" head bolt.

I working on a 24V to 12V 5A DC-DC convertor and would like to know if there is any market/interest on this group. It will accecpt an input of 5 to 32V and output a regulated 12V.

I have seen some folks asking an exorbitant price for vinyl cab tops ($250+) You can order one straight from the manufacturer for ~$170. It takes about a month to get. They also have cargo covers and bows. http://www.gmacover.com/

My sprag doesn't work in this sub freezing weather and I can't get around without the front axle. It is adjusted fine and works in reverse. If I start from a stop, it works (sprags catch). The sprags will not catch when in motion. There are no air shift transfer cases in my area (within...

I just swapped out my non functioning sprag for another sprag. The good news is that the sprag works but the transfer case slips out of low range on occasion. It seems to do it under low load such as between shifts. I have noticed that it takes very little movement of the lever for it to slip...

I ordered up one of these. Compact and cheap. http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=4561052064

Where is the cheapest place to get the axle nut/spindle socket? Local place wants >30 dollars. Are the front and rear the same size nut?

Anyone know if the crankshaft thrust washers on the reo gas engine can be replaced without dropping the crank? It appears that I can remove the timing cover and crank gear to replace the front washer. If I remove the front main cap can the the thrust washer be turned/slide out? I have ~0.022...