Search results

Are these the correct nsn's for the two? I'm about to purchase them but don't want to make an expensive mistake: Ecv body harness:6150-01-432-3582 Turbo engine harness:6150-01-433-1568

Anyone know of an engine cradle that would work well for wheeling around a complete power pack in the shop? Check out the pic. I'm looking for something similar. Currently my engine/trans/tcase is just sitting on its side on two crushed pallets. I hope to start getting it cleaned up and...

I'm in the process of removing the early rear seat bases. What's the best way to remove all those rivets?

Does anyone know if these engine lift brackets that are from am general fit the 6.5 turbo engine as well?

I'm thinking about buying the gantry lift from Harbor Freight for lifting my engine into place and possibly later on taking the body off the frame. Is the gantry overkill or can I do it all with a cherry picker?

I'm working on the ecv front end and hood. I'm looking at the parts manual at the 2 different frame extension parts. Neither list m1151 at the top of the page but I'm not sure that matters. Can either setup work to support the ecv front nose grill? What about ecv with winch setup?

I have a hmmwv hood in NC I need brought up to Ohio. They're fiberglass and light, just on the bigger side. It's crated but can be removed if necessary. PM if you can help me out.

I found some radiator paint made by Eastwood. Are these ok to spray on the fins of your rad? I'd like to clean things up a bit but not if it ruins the cooling quality of the radiator.

Does anyone have any manuals on the cp-1995 or good sites that have info on it?

With the rt-1523 style radios in the hmmwv's was there just a single speaker per radio or two speakers per radio? It's hard to tell from some of the pics.

What is an appropriate match for the hand held gps units for the hmmwv? Hoping someone can list exact models.

Any one make runs from Cleveland, Tenessee to Northeast Ohio? I've been looking at a hmmwv soft top and was wondering if anyone could bring it up for me.

Would anyone have the driver side support tube that is typically attached inside a rear sponson?

This question must come up every 5 minutes...hopefully this isn't too annoying and someone will give me some ideas. I'm planning to completely tear things down and start sand blasting and repainting all the frame, suspension parts, etc of my hummer this winter. I'm thinking of going for a flat...

I have a lot of small parts and was wondering if anyone has used one of those vibrating containers full of rock? Or steel beed? I'm not sure what's in them. But they're basically a container that vibrates and its full of a media of choice with your part in it. Takes a while but it should...

What parts are prohibited from being sold/exported to canadians? From what I know GL has certain restrictions on their sales. Would something like a roll bar be ok to sell to someone up north? All my parts I'm interested in selling have been through private sales.

Looking to get an H1 moved. It's running just fine.

Anyone have a roof support for a turret they wanna sell?

Do the armored roofs go overtop the regular roof as armored panels or would it replace the roof altogether?

Haven't seen any hard tops for the truck/2 seat configuration. Are many around?