Search results

Scooter, I think you need that to go get your 108:-D BC

Thanks DH, Haven't had any vibrarion problems with my temporary OP gauge copper line but just wondered if there was some good other alternative. Thanks, BC

I picked up a Gov. issue mechanical 0-80 PSI oil pressure gauge that I am going to install in the instrument panel, even has the slots so the dash lights will light it. What are your thoughts on the tubing I should use to connect it to the sender port? Copper or synthetic? Thanks, BC

I'm with several of the others that have posted in this thread. Everything seems to be right in a comfort zone with the engine, truck and me at about 51 to 53 MPH. She's a one hand on the steering wheel driver, vibes are minimal, exhaust tone is nice and I really get to notice things by the side...

ida34, I believe you will find that the TM says adjust the alt. output to 28volts +/- .2 volts. BC

You are welcome. Glad it worked. And Meatloaf said " two outta three ain't bad":-D BC

Thanks grounded, wasn't using the selection choice. Now all I have to do is figure out how to enlarge the print so I can read it:roll: BC

Is there some sort of print feature that allows one to print a PM without printing all the other stuff on the page? Thanks, BC

Have you checked to see if it sucked up a lot of junk that may have been in your tank? You can take the bottom apart, remove the shims and so forth and see what happens. It's a long shot, but cheaper than another pump. You can see the pieces that will come out in the attached pic.

Wild Horse, you went parts hunting today. Does that mean scooter went with you and looked for my part:-D? BC

From TM 5-6115-271-14 Flashing the field without a switch 1. open or remove control box cover 2. Connect two 1.5 volt batteries in series and connect a wire to each end. 3. connect the positive wire from the batteries to terminal No. 20 on the voltage regulator. 4. start the generator set 5...

"This topic has been brought up before but never addressed by the site programmer. Apparently, it's too confusing." You always have to twist the knife just a little, don't you Mike :wink:. BC

Have more pics for you. Can't send them. BC

Stretch, it draws from inside the cab. With a rag top and all the places for air infiltration there is no problem with using up all the oxygen and passing out:-D. I can crack the vent on that side to let fresh air in also. The beauty of it is that the fan doesn't have to push the warm air from...

As I have said before, put it in the cab. BC

Here is something I found and saved when I was rebuilding my airpack. Take heed of the possibility that the directions that you followed may be incorrect. The incorrect info happens to be in TM 9-2320-209-34-2-1 as per attachment. BC

I think I've read that guys put a 4x4 from door to door with the windows down and use a come-a long--- cheaper than an electric hoist. Might need soldier "B" to help with that method. BC

Chuck, Just got your PM. I think you nailed it. Thanks much, BC

Does anyone know how to make these headsets with the two prong plug work with a VIC1 control box or cable to eliminate the pesky snap type "bailout" connectors?

Does anyone have these manuals they can upload? Can anyone tell me where the best info is on R & R of the turbo if it's in the resource section? Started blowing blue smoke the last 10 miles of the ride home from Lowell yesterday and by the time I backed in my driveway the whole neighborhood was...