Search results

[ I did not remove the metal parts on the bottom of the original master cylinder cap when I did the job. Others have said you need to do that but my experience so far it made no difference. I think that fitting is a check valve. It may not let fluid into the master cylinder only lets air out...

I thought the only difference from the 5 ton and 2.5 ton motors were the intake manifold and air inlet ( air filter etc). I got a m109 that has the bigger intake and a turned up ip and that thing flys uphill way better than my M35a2

Once you get the clearance to pick it up. They want it gone. No working on it other than jump starting , load n go.

That should be a vent line. If it had a resivour it would be mounted in the cab behind the drivers seat. It’s a common failure for these trucks to loose peddle , leaks in the air pac , wheel cylinders , failed break lines. Most common is the wheel cylinder followed by the air pac. Should be dot...

nopicsnopics

I think someone added that to charge Thier phone.

I’m guessing it’s the pine tree drain. Seen it before. 😉

I’m just trying to throw some ideas out there. I’ve had trucks sit for months and start with a little extended cranking but fired up. Anything over 600 rpm should fire up. 🤔 And I can’t see the injection system draining back into the tank , the filter shells should hold quite enough fuel to get...

Have you pulled the ip head to make sure the button is still attached ? It migh be loose and only staying attached when the rpm’s get up there. I hated pulling that whole assembly off because it wouldn’t start. Turned ou it was the ip head button off and the piston wouldn’t drop all the way down.

Fresh from depo refurbish. Will throw in extra tank to seal the deal. Needs paint and hole repair ;)

Mine will usually blow smoke if it’s sitting at idle for an extended time and mine has a turbo.

No it will not. Only increase amount of fuel delivered. Not pressure

I would start by checking for broken wires and bad grounds. Melting the cover 😳 are you sure the correct lamps are in the correct receptacle ? The top lamp should be for turn signal and middle is for parking lights. Bottom is blackout turn. I’m pretty sure.

The only experience That I had with any sort of a V-8 replacing a straight 6 was after the V-8 had failed ( still ran but the thrust bearing was wasted ) it was in a M-211 GMC and the 302 6 was replaced with a 455 V8 It don’t have any of the low end tork the straight 6 had ( I had an M-135 at...

Using mine today as the flag holder

Never seen this before. not in a heated debate that I could see.

I think before everyone goes off the deep end on this guys poor truck , I’m sure you got a bleeder just killing 1 battery. Without disconnecting any of the battery’s I think you need a current sensing meter to see if there’s a drain. They come in different styles but something like this...

Something like this

The one I had was more of a burgundy color for seats and dash. That blank should have had a badge for Silverado or something like that. No a mv dash

I got a set for my funvee. All looked like brand new. Just ask That they send you all the Same load range. Got 5 from them, 4 were E’s 1 was a D range. Just use it as a spare anyway.