Search results

well , I understand that issue , not to incriminate myself any further , I may work and “live” in ca. for the week but I go home . I have an az address and dl now , this state that I “had” lived in for the past 60+ years sucks on every level that they can when it affects my life. I am counting...

that’s why my funvee is owned by my LLC in Montana. CA. Was a hard no , tried the historical plate way cuz it’s over 20 years old. Got frustrated and now I got perm plates , never got to register it again , just got to keep up with the llc.

I thought I thought they were all fiberglass on the funvee. 🤔 the only wood ones were on my m35 or older trailers

Put on a new top and converted it to a billboard.

That’s now the gremlins tool , net tine you hear a rattle it’s ur gremlin takin it apart at speed. 😉

That would nice sitting in front of my legion 😉

First. Wtf ?? Holes like that in the hood ?? I get where the front near the reflectors get tore off due to getting too close but wth ?? Nice repair job 👍. I’m guessing those lug nuts are on that way for the low drag coefficient. 😎

If your gonna do show n tell you should include a link 😉 I’m having a little trouble finding them for some reason.

Too bad. In reading the info it looks like the took the pics before they removed all the rotor blades , stabling stuff and windows. I wonder if they include all the stuff they pulled ? Except for the gun and nvg.

I’ve done a bit of driving with the 14’s and the 7’s. They make a version for flying that have dual tubes the help with depth perception , wouldn’t try with any off the shelf thermal. Driving an armored vehicle ? Sure. Not gonna care unless I hit another tank. unless your going straight down a...

On the back of a rollback heading back home 🤣

Me too !

I don’t even want to say how long I ran in tires that were from 56 and capped and had cracks that made those looki like yours still had nipples on them. Wouldn’t recommend going full load or speed. Those are surface cracks till Thier not anymore. Not saying you should drive on anything other...

Another win for SPRAY N PRAY 🤣

That motor fires on pressure only , carb cleaner don’t work. I would pull the air filter and use a “little” either. Most people that post here hate that word but it will tell you if you got enough compression to detonate diesel fuel. Don’t over do it. Just a good spray. At least you’ll know if...

If you timing marks line up you should be good. To verify you have fuel by using the air pressure on the fuel tank to push fuel up to the ip, open the air bleeds on the top of the fuel filters on the side of the motor until straight fuel comes out than bleed up to the ip , if you have fuel up to...

I would check the crank bearing while you got the pan off. Excessive wear may make the rear seal leak worse , those old trucks have been run hard at max rpm causing excessive wear.

It should take between 60 to 120 psi to activate the switch. Either the switch has failed or the master cylinder has an issue , it should release the line pressure back when the peddle is released

Got my Montana plates threw DL , perm plates good till 99-99. I live in ca where they refused to do anything , would use them again . Go team BETH 👍