Search results

:ditto: mine just bounces around

how much shipped to 06605 bpt CT?

:( well i flushed out most... and my heater core is working so i'll just pray.

where is it exactly and where do you need it to go? i'm in CT and if my CUCV can haul it i'd love to.

I have been searching and trying to find out why i can load the chat rooms and read what everyone is saying. I however cannot interact with it at all. I am running Ubuntu 9.10 Karmic Koala on an HP DV6400 laptop. I have 2 gig of ram. I currently have flash installed through the ubuntu...

i need this thing.

honestly had he not been there. i would never have checked. This is why i don't like to work alone. you can check eachother. I'm glad he was there. :beer:

oooh tractor supply.... how bout the actual steel square posts for the shackles... my rears are missing.

yea i know... and you wanna know why it was leaking... my buddy when i RTV'd the gaskets said don't tighten it all the way let it set then tighten... they were loose. Basically i'm stupid and after tightening everything all is well. i think i'm going to drain out that stop leak **** tomorrow...

stop leak seems to have solved my problems.... will update after i drive it around tomorrow

yes yes and no i also didn't crank on them very tight... then tried a little tighter. I'm gonna try and redo everything in a bit

ok well got new part thanks to magnus and everything is all hooked up... and leaking. Ever single connection is leaking. so i'm waiting for it to stop leaking then going to take everything off redo gaskets and then RTV everything. i know rtv is bad and whatnot but i'm kinda done messing with...

lmc truck sells the sensor and its not cheap... i currently go with the "oh they are going a little faster than me... i'm probably good" method

mangus thank you kind sir! thank you much.

bunker... please don't make me even think about that as this ordeal turned into a complete disaster

ohh sweet i thought you meant you had 2 welders... how much for one? and where abouts are you? i may be able to come pick it up.

is it possible to use an oxy acetylene torch to heat the bolt itself and blow it out?

i can't find the part... and then that means i have to pull 4 more steel bolts in aluminum most likely they will break as well. All i have to heat it with is a MAP gas torch. No oxy/acetylene. Who can i call that will have some means to helicoil it? keep in mind it is now drilled waaaay off...

i found out it's an M10x1.5 bought the helicoil kit today and pulled the top bolt. Bottom bolt is trashed and i'm kinda in a bad way.

bottom bolt is screwed... my buddy was helping me out for a bit while i addressed my busted finger... he drilled off center and its now a complete mess... anyone have any ideas? i'm kinda at a loss here...